DRAFT
User Manual
DMMR
Rev 1
Note:
The digital portion of the transceiver has been tested and found to comply wi th the limits for a Clas s B
digital device, pursuant to part 15 of the FCC Rules. Thes e limits are designed to provide reasonable
protection against harm ful interference in a residential inst allation. This equipment generates, us es and
can radiate radio frequency ener gy and, i f not installed and used in ac cordanc e with the ins tructions, may
cause harmful interference to radio comm unications. How ever, there is no guar antee that interfer ence will
not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be det ermined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connect ed.
-Consult the dealer or an experienced radio/T V tech nic i an for help.
Page 1 of 5
DRAFT
Installation
Here we shall add the Installation Instructions which shall include the following
1. The user and the installer should be aware that changes and
modifications not expressly approved by Telematics Wireless could
void the user’s authority to operate the equipment.
2. The antenna used for this transmitter must be installed to normally
provide minimum separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction with any other
antenna or transmitter.
3. The transmitter duty cycle shall be equal or less than 20%.
4. The DMMR unit will be fully assembled (including antenna and cover)
at the factory/manufacturer (see pictures below)
statements:
Page 2 of 5
DRAFT
Page 3 of 5
DRAFT
Page 4 of 5
DRAFT
Page 5 of 5
Loading...