Telematics FP310RAM-X User Manual
PROPRIETARY INFORMATION
ALL RIGHTS RESERVD, NO PARTS OF THIS DOCUMENT MAY BE REPRODUCED, STORD IN
RETRIEVAL SYSTEM, OR TRANSMITTED IN ANY FORM OR BY ANY MEANS, ELECTRONIC,
MECHANICAL PHOTOCOPYING, RECORDING OR OTHERWISE WITHOUT THE PRIOR WRITTEN
PERMISSION OF TELEMATICS WIRELESS LTD. NOR USED IN WHOLE OR IN PART FOR ANY
PURPOSE OR FOR ANY CUSTOMER EXCEPT TELEMATICS WIRELESS.
NAME:
FP310RAM-X
User Manual
DESIGNED
M.N.
March 2009
SHEET/OF
CHECKED
G.F.K
March 2009
1
21
APPROVED
A.S.
March 2009
Q.A.
A.S.
March 2009
PROD/PROJ: FP310RAM-X ASTM Mini Reader
SIZE
2 1 4 0 7 2 0 4 6 0 0
0
REV.
DESCRIPTION
E.C.N.
DATE
DRAWN
CHECKED
A
PROPRIETARY
Note:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may
cause undesired operation.
WARNING! Changes or modifications to this unit not expressly approved by Telematics
Wireless Ltd. could void the user's authority to operate the equipment.
The digital portion of the transceiver has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by the
following measure:
-Increase the separation between the equipment and receiver.
The antenna and therefore the unit, used for this transmitter must be installed to normally provide
minimum separation distance of at least 2 meters from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter.
Table of Contents
PROPRIETARY
ii
FP310RAM-X
Mini Reader
User Manual
Version 1.1
Telematics Wireless Ltd.
26 Hamelacha St., POB 1911
Holon, 58117
Israel
Phone: +(972)3-5575717
Fax: +(972)3-5575713 March 2010
This document contains proprietary information, which is the sole
property of Telematics-Wireless. The document is submitted to the
recipient for his use only. By receiving this document the recipient
undertakes not to duplicate or to disclose in part of, or the whole of, any
of the information contained herein to any third party without receiving
before hand, written permission from the submitting company.
Table of Contents
PROPRIETARY
iii
Table of Contents
Page
Chapter 1 ...................................................................................................................... 1-1-2
Introduction .................................................................................................................. 1-1-2
1-1. Scope ............................................................................................................. 1-1-2
1-2. General Description ....................................................................................... 1-1-3
1-2.1 Purpose and Use ............................................................................... 1-1-3
1-2.2 Main Technical Characteristics ........................................................ 1-1-3
1-2.3 Host Utility ....................................................................................... 1-1-3
1-2.4 Additional Equipment Needed .......................................................... 1-1-3
1-2.5 FP310RAM-X vs. FP300RA ............................................................ 1-1-4
1-3. Physical Description ...................................................................................... 1-1-4
1-4. Functional Description .................................................................................. 1-1-5
1-4.1 Normal Mode .................................................................................... 1-1-5
1-4.2 Mute Mode ........................................................................................ 1-1-5
1-4.3 Maintenance Mode ........................................................................... 1-1-5
1-4.4 Host Communication ........................................................................ 1-1-5
Chapter 2 ...................................................................................................................... 2-2-1
Installation ................................................................................................................... 2-2-1
2-1. General........................................................................................................... 2-2-1
2-2. Installation Requirements .............................................................................. 2-2-1
2-2.1 Integration in Systems ...................................................................... 2-2-1
2-2.2 Safety Considerations ....................................................................... 2-2-1
2-2.3 Mechanical Data ............................................................................... 2-2-2
2-3. Installation Guidelines ................................................................................... 2-2-2
2-3.1 Power Requirements ......................................................................... 2-2-2
2-3.2 Antenna ............................................................................................. 2-2-2
2-3.3 Communication Cables ..................................................................... 2-2-3
2-3.4 Grounding and Lightning Protection Requirements ......................... 2-2-3
2-4. Installation Procedure .................................................................................... 2-2-3
2-4.1 Tools and Materials .......................................................................... 2-2-3
2-4.2 Preparation for Installation ............................................................... 2-2-3
2-4.3 FP310RAM-X Installation Procedure .............................................. 2-2-4
Chapter 3 ...................................................................................................................... 3-3-1
Operation ..................................................................................................................... 3-3-1
3-1. Scope ............................................................................................................. 3-3-1
3-2. Power-Up ....................................................................................................... 3-3-1
Appendix A .................................................................................................................. A-1
Connection Data .......................................................................................................... A-1
A-1. Antenna Connector .......................................................................................... A-1
A-2. Power Input Connector .................................................................................... A-1
A-3. Host Interface Connector ................................................................................. A-1
A-4. I/O Connector .................................................................................................. A-1
Table of Contents
PROPRIETARY
iv
List of Illustrations
Figure 1-1. FP310RAM-X, General View ....................................................................................... 1-1-3
Figure 1-2. FP310RAM-X, Host Side Panel .................................................................................... 1-1-4
Figure 1-3. FP310RAM-X, Antenna Side Panel .............................................................................. 1-1-4
Figure 2-1. FP-310RA Connections ................................................................................................. 2-2-1
Figure 2-2. FP310RAM-X Mechanical Data ................................................................................... 2-2-2
List of Tables
Table 1-1. FP-310RA Connectors, Indicators and Controls ............................................................. 1-1-5
Table A-1. DC IN Connector, Pin Functions ...................................................................................... A-1
Table A-2. HOST Connector, Pin Functions for RS-232 Interface ..................................................... A-1
Table A-3. I/O Connector .................................................................................................................... A-1
PROPRIETARY
1-1
Chapter 1
INTRODUCTION
Contents
1-1. Scope ................................................................ ............................................. 1-1-2
1-2. General Description ....................................................................................... 1-1-3
1-2.1 Purpose and Use ............................................................................... 1-1-3
1-2.2 Main Technical Characteristics ........................................................ 1-1-3
1-2.3 Host Utility ....................................................................................... 1-1-3
1-2.4 Additional Equipment Needed .......................................................... 1-1-3
1-2.5 FP310RAM-X vs. FP300RA ............................................................ 1-1-4
1-3. Physical Description ...................................................................................... 1-1-4
1-4. Functional Description .................................................................................. 1-1-5
1-4.1 Normal Mode .................................................................................... 1-1-5
1-4.2 Mute Mode ........................................................................................ 1-1-5
1-4.3 Maintenance Mode ........................................................................... 1-1-5
1-4.4 Host Communication ........................................................................ 1-1-5
Scope
PROPRIETARY
1-2
Chapter 1
Introduction
1-1. Scope
This manual covers the characteristics, applications, installation, configuration and maintenance of the
FP310RAM-X mini reader, an advanced and flexible roadside component offered by Telematics Wireless
for use in electronic Automatic Vehicle Identification (AVI) systems.
The information included in this manual is organized as follows:
Presents the manual scope and organization, and describes the
FP310RAM-X mini reader functions and capabilities.
Chapter 1 – Introduction
Provides the information needed to plan the FP310RAM-X installation,
and detailed installation instructions.
Chapter 2 – Installation
Provides information on the FP310RAM-X operating modes.
Chapter 3 – Operation
Presents the information needed to connect to the FP310RAM-X.
Appendix A –
Connection Data
For additional information on the FP310RAM-X technical specifications, its systems integration, help in
interfacing to the FP310RAM-X, and other issues regarding utilization of FP310RAM-X advanced
characteristics, contact Telematics Wireless.
Loading...