Telecom Cellular Repeater, Clear Voice Installation And Operation Manual

Clear Voice Cellular Repeater

Installation and Operation Manual

Home and Office Indoor Repeater

Telecom Technologies (USA) LLC

26112 Hitching Rail Road,

Laguna Hills, CA 92653

Tel: + 949 690 5056

Fax: + 949 349 0723

Email: [e-mail]

www.cellboosterstore.com

Clear Voice Repeater Installation and Operation manual

Congratulations on the purchase of

your new Clear Voice Cell Repeater!

Safety First

For your safety and to prevent injury to the installer or the operator, it is essential
to read this manual carefully before your new unit is installed and operated.
_____________________________________________________________________



Through out this document this symbol indicates potential injury incase the operator

fails to follow the guideline or common sense during the installation of the repeater unit.

Personal safety

 This unit is powered by small AC adaptor unit. Turn off the electricity supply if

you have to do any rewiring or making alterations to wall sockets.

 The equipment should be used only for amplifying mobile (cellular) phone

signals and not for any other purpose.

 Should the unit fail to operate, any repairs should be carried out by qualified

personnel ONLY.

 The RF energy that the unit radiates is very small (max of 5mW) this level is

many times smaller than the RF power radiated by your mobile phone.

Telecom Technologies (USA) LLC

www.cellboosterstore.com

Clear Voice Repeater Installation and Operation manual

General Repeater Information

Introduction

Almost all of us have experienced a dropped call or “Service Not Available”
messages on our cell phones. This phenomenon occurs because there is
inadequate signal strength from the cellular towers that provide network
coverage. You see the base station cellular towers along roadsides, on top
of communications towers, and installed on some buildings in urban areas.
Often transmission to and reception from a cellular tower is weak because
the tower is such a long way away from the mobile unit. Other times,
buildings block the cellular signal or make it patchy. Full coverage is quite
rare, and due to “poor reception” we experience interruption of conversations,
voice distortion and dropped calls.

The Clear Voice Cellular Repeater is the solution to this problem. Repeaters
not only amplify the weak received signal, but they also reduce the need for
high level of RF transmission from your cell-phone, reducing undesirable
radiation exposure and battery drainage. The Clear Voice Cellular Repeater
is ideal for areas such as offices, apartment blocks and homes where your
phone is ordinarily unable to get adequate reception. By boosting the signal,
this device enhances the signal from your handset, ensuring a reduction in
noise and call drops, and so better quality of service.

So how does it work?

Look at the image on the next page to understand the setup of the Clear
Voice Cellular Repeater kit. The repeater is made up of two main parts: the
directional panel antenna and the Clear Voice amplifier unit. The directional
panel antenna is aligned with the closest cell phone tower, and collects the
cellular signal. This signal is then sent via a 30-foot cable to the Clear Voice
amplifier unit. The amplifier unit boosts the signal, and then retransmits it
about your home or office using a monopole broadcast antenna.

Telecom Technologies (USA) LLC

www.cellboosterstore.com

Clear Voice Repeater Installation and Operation manual

Telecom Technologies (USA) LLC

www.cellboosterstore.com

Clear Voice Repeater Installation and Operation manual

Clear Voice Repeater Kit Contents

1. Clear Voice Amplifier unit

Output to

Monopole Antenna

labeled “SERVICE”

Signal strength

and fail

indicator lights

Power and Alarm

Lights

Input from

Directional Panel

Antenna labeled

“BTS”

2. Directional Panel Antenna
unit (and fixtures)

3. Monopole Antenna unit

Telecom Technologies (USA) LLC

www.cellboosterstore.com