TeleAlarm RM-LES900 Operating Instructions Manual

Wireless Smoke

Detector

RM-LES900

Operating Instructions

Wireless Smoke Detector RM-LES900

1 Use, Transport and Storage

1.1 Use

The radio mounting base is intended solely for use in connect ion with the smoke det ector
head for optical detection of smoke development from fire. It is for indoor use only.
Before you mount it, test the radio range at the installation site:

 Put the battery into the radio base
 Screw the smoke detector head into the radio base
 Switch off all possible sources of electronic interference in the room, such as

televisions, radios, mobile phones and computers.

 Prepare the TeleAlarm Carephone for connection
 Press the alarm head – Warning: A short, loud signal will sound
 Make sure the connection between the wireless smoke detector and the TeleAlarm

Carephone is working

 Trigger a test alarm by pressing the smoke detector head

CAUTION

Danger of explosion and fire

Replacing the battery by an incompatible type or inserting it with reversed polarity can
cause excessive heat, fire or explosion.

Danger of hearing loss

The Wireless Smoke Detector generates a very loud and shrill tone. When testing its
function keep a minimum distance of 50cm or wear suitable ear protectors.

The alarm call should be triggered after pressing the alarm head just once. If the
alarm call is only triggered after repeatedly pressing the button, the radio connection is not
stable. Find another set-up location for the TeleAlarm Carephone and repeat the
connection test. Observe all provisions, norms and safety rules applicable at the
installation site.

Do not use in rooms where the ceiling is higher than 6m.

Wireless Smoke Detector RM-LES900 Page 1/7

Wireless Smoke

Detector

RM-LES900

1.2 Transport and Storage

The product can be damaged from improper transport and storage.

 Only transport in the original packaging.

 During storage and transportation, the specified ambient conditions must be

maintained.

 The dev ices must be protected from impact when stored and during transport.

Failure to heed these instructions can lead to damage that does not fall under
guarantee and warranty.

Wireless Smoke Detector RM-LES900 Page 2/7

base plate

radio mounting base

assembly

Wireless Smoke

Detector

RM-LES900

2 Product Description

2.1 Overview of Components

Wireless Smoke Detector RM-LES900 Page 3/7