TeleAlarm MIYSD User Manual

Author: TeleAlarm SA Edition: April 2009 Document N°: 953-24c

MIYSD Wireless Smoke Detector – Set-up Information

Installation and Power-up

Please refer to the original manufacturer's instructions.

Programming

The smoke detector needs to be registered in the alarm receiver unit. Please refer to the User
Manual of the NurseCall Main Unit or Carephone.

Operation check

It is strongly recommended to perform an operation check of the installation on a regular
basis:

 Let the alarm receivers and everyone around know that you are going to perform a test.
 Push the test button on the smoke detector and hold it down until emission of the alarm.
 Check that the alarm has been recognized by the receiver, it should acknowledge.

WARNING: triggering an alarm generates a powerful (85 dBA) acoustic signal!

Environmental note

This product has been made from high-quality parts and materials which can be
re-used and recycled. Therefore, do not throw th e product away with normal
household waste at the end of its life. Take it to a collection point for recycling

electrical and electronic devices. This is indicated by the symbol below on the
product and on the packaging as well.
Please find out about collection points oper ated by you r local authority.
Help protect the environment by recycling used products.

FCC Warning Statement

This equipment complies with Part 15 of the FCC rules. Any changes or modifications not
expressly approved by the manufacturer could void the user's authority to operate the
equipment.

This device complies with Part 15 of the FCC rules subject to the following two conditions:

1) This device may not cause harmful interference

2) This device must accept all interference received, including interference that may

cause undesired operation.

Page 1 of 1