TEL CP3010, CP3010, CP301, CP301, CP300 Datasheet

CP300 THRU CP3010

SINGLE-PHASE SILICON BRIDGE-P.C. MTG 2A, HEAT-SINK MTG 3A

VOLTAGE - 50 to 1000 Volts CURRENT - 3.0 Amperes

FEATURES

l Surge overload rating—50 Amperes peak
l Low forward voltage drop and reverse leakage
l Small size, simple installation
l Plastic package has Underwriter Laboratory

Flammability Classification 94V-O
l Reliable low cost construction utilizing molded
plastic technique

MECHANICAL DATA

Terminals: Leads solderable per MIL-STD-202,
Method 208
Weight: 0.08 ounce, 2.5 grams

CP-3

MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS

At 25 ambient temperature unless otherwise noted; resistive or inductive load at 60Hz.

Max Recurrent Peak Rev Voltage 50 100 200 400 600 800 1000 V
Max Bridge Input Voltage RMS 35 70 140 280 420 560 700 V
Max Average Rectified Output at TC=50*
See Fig.2 at TA=25**

CP300 CP301 CP302 CP304 CP306 CP308 CP3010

3.0

2.0

UNITS

Peak One Cycle Surge Overload Current 50 A
Max Forward Voltage Drop per element at

1.0 V

1.5A DC & 25. See Fig.3
Max Rev Leakage at Rated DC Blocking
Voltage per element at 25

10.0

1.0
See Fig.4 at 100
I2t Rating for fusing ( t<8.3ms) 15.0 A2Sec

Typical Junction capacitance per leg(Note 4)CJ

Typical Thermal Resistance per leg(Note 2) RJA
(Note 3) RJL

21.0

12.0

8.0
Operating Temperature Range -55 TO +125
Storage Temperature Range -55 TO +150

NOTES:

1. Bolt down on heat-sink with silicon thermal compound between bridge and mounting surface for
maximum heat transfer with #6 screw.

A

A

mA

F

P

/W




2. Unit mounted on 4.0×4.0×0.11” thick (10.5×10.5×0.3cm) AL. Plate.

3. Unit mounted on P.C.B at 0.375”(9.5mm) lead length with 0.5×0.5” (12×12mm) copper pads.

4. Measured at 1 MHz and applied reverse voltage of 4.0 Volts.

RATING AND CHARACTERISTIC CURVES
CP300 THRU CP3010

Fig. 1-NON-RECURRENT SURGE RATING Fig. 2-DERATING CURVE FOR OUTPUT
RECTIFIED CURRENT

Fig. 3-TYPICAL FORWARD CHARACTERISTICS Fig. 4- TYPICAL FORWARD CHARACTERISTICS