5KP SERIES
GLASS PASSIVATED JUNCTION TRANSIENT VOLTAGE SUPPRESSOR
VOLTAGE - 5.0 TO 110 Volts 5000 Watt Peak Pulse Power
FEATURES
l Plastic package has Underwriters Laboratory
Flammability Classification 94V-O
l Glass passivated junction
l 5000W Peak Pulse Power capability on
10/1000 S waveform
l Excellent clamping capability
l Repetition rate(Duty Cycle): 0.05%
l Low incremental surge resistance
l Fast response time: typically less
than 1.0 ps from 0 volts to BV
l Typical ID less than 1A above 10V
l High temperature soldering guaranteed:
300/10 seconds/.375”,(9.5mm) lead
length/5lbs., (2.3kg) tension
MECHANICAL DATA
Case: Molded plastic over glass passivated junction
P-600
Terminals: Plated Axial leads, solderable per
MIL-STD-750, Method 2026
Polarity: Color band denotes positive
end(cathode) Except Bipolar
Mounting Position: Any
Weight: 0.07 ounce, 2.1 grams
DEVICES FOR BIPOLAR APPLICATIONS
For Bidirectional use C or CA Suffix for types
Electrical characteristics apply in both directions.
MAXIMUM RATINGS AND CHARACTERISTICS
Ratings at 25ambient temperature unless otherwise specified.
RATING SYMBOL VALUE UNITS
Peak Pulse Power Dissipation on 10/1000S waveform
P
Minimum 5000 Watts
PPM
(Note 1, FIG.1)
Peak Pulse Current on 10/1000S waveform
I
SEE TABLE 1 Amps
PPM
(Note 1, FIG.3)
Steady State Power Dissipation at TL=75Lead Lengths
P
8.0 Watts
M(AV)
.375”,(9.5mm) (Note 2)
Peak Forward Surge Current, 8.3ms Single Half Sine-Wave
I
400 Amps
FSM
Superimposed on Rated Load, (JECED Method) (Note 3)
Operating Junction and Storage Temperature Range TJ,T
-55 to +175
STG
NOTES:
1.Non-repetitive current pulse, per Fig. 3 and derated above TA=25per Fig. 2.
2.Mounted on Copper Leaf area of 0.79in2(20mm2).
3.Measured on 8.3ms single half sine-wave or equivalent square wave, duty cycle= 4 pulses per minutes maximum.
RATING AND CHARACTERISTIC CURVES 5KP SERIES
Fig. 1-PEAK PULSE POWER RATING CURVE Fig. 2-PULSE DERATING CURVE