Instructions
Y400F
Software Upgrade
075-0873-00
This document applies to firmware version 2.204
and above.
www.tektronix.com
*P075087300*
075087300
Copyright © Tektronix, Inc. All rights reserved. Licensed software products are owned by Tektronix or its suppliers and
are protected by United States copyright laws and international treaty provisions.
Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c)(1)(ii) of the
Rights in Technical Data and Computer Software clause at DFARS 252.227-7013, or subparagraphs (c)(1) and (2) of the
Commercial Computer Software -- Restricted Rights clause at FAR 52.227-19, as applicable.
Tektronix products are covered by U.S. and foreign patents, issued and pending. Information in this publication supercedes
that in all previously published material. Specifications and price change privileges reserved.
Tektronix, Inc., P.O. Box 500, Beaverton, OR 97077
TEKTRONIX, TEK, and NetTek are registered trademarks of Tektronix, Inc.
Y400 Software Upgrade Kit
This kit provides software and instructions to upgrade your Y400 NetTek
Analyzer Platform system software to version 2.204 or greater.
Products
Instrument Serial number range
Y400 NetTek Analyzer Platform all
Minimum Tool and Equipment List
Required tools and equipment Part number
Windows--based PC with CD-ROM drive -- -- -- -- -- -- -- -- --
Y400 NetTek Analyzer Platform -- -- -- -- -- -- -- -- --
RS-232 Serial Cable (NetTek Analyzer
Platform standard accessory)
®
012-1379-XX
Kit Parts List
Circuit/figure
number
-- -- -- -- -- -- -- -- -- 1ea 075-0873-XX KIT INSTRUCTION: Y400F UPGRADE
-- -- -- -- -- -- -- -- -- 1 e a 063-3639-XX Y400 NetTek Analyzer Platform Utility and
-- -- -- -- -- -- -- -- -- 1ea 335-1402-XX OPTIONS LABEL, REAR PANEL
Time Required
The software upgrade process requires about 30 minutes to complete.
Y400F Software Upgrade Instructions
Quantity Part number Description
Operating System Installation Software
1
Y350C Software Upgrade Kit
Installation Instructions
To upgrade the operating system on your Y400 NetTek Analyzer Platform:
1. Connect the Y400 NetTek Analyzer Platform to your PC using an
RS-232 cable.
2. Power on the Y400 NetTek Analyzer Platform.
3. Insert the Y400 NetTek Analyzer Platform Utility and Operating System
Installation Software CD-ROM (Tektronix part number 063-3639-XX) into
your PC.
4. Follow the on-screen instructions that appear. If no instructions appear after
you insert the CD-ROM:
a. Use Windows Explorer to display the contents of the CD-ROM.
b. Double-click the NetT ek.htm file to display the installation instructions.
5. After upgrading the software, install the supplied label on the back of the
Y400 instrument.
Installing Option VCE
Option VCE (Virtual CE) is installed as part of the normal operating system
install; there is no separate installation procedure for Option VCE. Although
Option VCE is installed as part of the operating system, it must be enabled by an
options key. An options key is a coded text string that is tied to the serial number
and Global ID of the instrument. An options key works only on theY400 for
which it is purchased.
This kit contains a label that shows the options key required for enabling Option
VCE (if you purchased the option with this kit). When you first start Virtual CE
for NetTek, you will be prompted to enter the options key.
g End of document g
2
Y400F Software Upgrade Instructions
Loading...