Tektronix Rack Adapter Utility Drawer Field Install Instructions

Rack Adapter Utility Drawer for Tektronix Waveform
Monitors

Product Application

www.tektronix.com
Copyright © Tektronix

*P075097800*

075-0978-00

tility drawer and tray are designed to be installed in one half of the rack

This u
adapter for various models of the Tektronix waveform monitor. This drawer can
be used to house accessory items. With the tray secured to the rear of the rack
adapter, the drawer can be opened and closed freely, unless latched.

Rack Adapter Utility Drawer for Tektronix Waveform Monitors

Installation Instructions

CAUTION. Ensure that the tray is secured to the rear of the rack adapter before

opening the dr
before transporting.

awer. Latch the drawer (by turning the thumbscrew fully clockwise)

1. Remove and s

2. Install the tray and drawer together into one half of a rack adapter.

3. Secure the tray to the rear of the rack adapter using the screw that was

removedinstep1.

NOTICE. Fo

rack adapter. To do this, install a screw through the remaining hole in the rack
adapter, and into the hole in the back of the drawer.

4. Disengage the drawer latch by turning the thumbscrew fully counterclockwise.
The drawer can now be opened and closed, as wanted.

5. Fasten the drawer latch again (turn the thumbscrew fully clockwise) for use in
mobile units or any time the rack will be moved.

6. To remove the drawer and tray from the rack, first remove the securing screw
from the back of the tray. Then, carefully slide the tray and drawer forward
and pull them completely out of the rack.

7. To remove the drawer and tray from the rack, first remove the securing screw
from the back of the tray. Then, carefully slide the tray and drawer forward
and pull them completely out of the rack.

ave the screw from the rear of the drawer tray.

r other applications, the drawer can also be secured to the rear o f the

2