Tektronix P7700, TDP7700 Quick Start Guide

*P070738601*
070-7386-01
P7700 and TDP7700 Series TriModeTM Probes
Quick Guide
TekFlexTM Accessory Options
Standard Accesories
Adhesive Tape
P/N: 020-3167-00
Optional Accesories
Active Tip
P77STFLXA
Wire Spool
P/N: 017-0103-00
Color Bands
P7700: 016-1948-00 TDP7700: 016-2111-00
Large Metal Cable Band
P/N: 129-1867-00
Browser
P77BRWSR
Coaxial Tip
P77STCABL
Browser Pen Wand
P/N: 020-3160-00
Active Tip
P77STFLXB
P/N: 020-3161-00
Magnetic Cable Holder
P/N: 121-1003-00
Browser Replacement Tips
P/N: 020-3162-00
Browser Adapters
P/N: 020-3163-00
Small Metal Cable Band
P/N: 129-1857-00
Ground Lead
P/N: 196-3436-00
Get to know your Browser
Assembling the Browser
1. Insert TekFlex Connector
2. Attach collar, lock in place with thumb screw
Turn Clockwise to lock,
Counterclockwise to Unlock.
Pinch to Open
Adjusting the tip spacing
5.3mm (0.210 in) maximum
0.2mm (0.008 in) minimum
The Spotlight
Depress switch to activate the spotlight.
Spring action, better grip
.5mm (0.019 in) compression
Connect the Tri-pod
A
B
3. Attach browser pen wand or tri‑pod
A
or
B
Install circular end of the shaft into tri‑pod and plus side into the browser.
Testing your circuit with the solder-in-tips
Step
1A
Step
1C
Step
Step
2
or
3
Step
Orient the Flex Tip with the key feature as shown. Pinch to open TekFlex connector, slide tip into slot until it stops. Releasing TekFlex connector should lock tip into place.
3
Step
For additional strain relief mount magnetic bar to metal surface near DUT. Attach Metal Cable Band to boot or cable, then attach to Magnetic Cable holder.
4
Step
1B
Step
1D
Step
Step
Apply tape to the bottom side of the ex circuit near tip if needed. To extend life of ex circuit do not bend sharply.
4
Step
Solder wire to test points. Slide tip down onto wires. Position tip close to board and solder wire to end of tip. Snip off & remove excess wire.
*See manual for detailed instructions
1
2
Loading...