Instructions
P6864
High Density 4X Logic Analyzer
Probe Label
071-1313-00
*P071131300*
071131300
P6864 High Density 4X Logic Analyzer
Probe Label
These instructions provide a detailed description of how to attach
probe labels to your Tektronix P6864 High Density 4X Logic
Analyzer Probe. Tektronix also provides additional labels for
customizing the probe (see Figure 1-1).
Attaching Probe Labels
NOTE. Always use flat-nosed tweezers to remove the labels from the
sheet of labels. Peeling the label can stretch and distort i t. To avoid
stretching the label, always grasp it from the top right corner while
removing it from the sheet of labels.
NOTE. The adhesive on the vinyl labels is extremely strong. Carefully
align the label to the indented outline on the module end and way
stations before attaching it to the probe. Once labels are placed on
the probe, they become very difficult to remove.
You will be attaching labels to both module ends and both sides of
the probe head. Refer to Figure 1 and Figure 2 while attaching the
probe labels.
Copyright © Tektronix, Inc. All rights reserved.
1
P6864 High Density Logi c Analyzer Probe Label
To attach probe labels, perform the following steps:
1. Determine which module connectors you are planning to use and
identify the matching labels. Refer to your logic analyzer module
to identify the number of probe connections (dependent on the
number of channels in the module) and the channel color coding
that corresponds to the provided sheet of probe labels.
2. Identify the probe head. See Figure 2.
3. Using a pair of flat-nosed tweezers, place the tip of the tweezers
beneath the upper right corner of one of the two probe head
labels. These labels will be the smallest of your four labels. Grasp
the corner of the label and lift the label up and toward you.
4. Carefully align the label to the similar shaped label indent located
on the probe head and apply the label.
5. From the probe head, follow down the length of the ribbon cable
(located on the side of the probe head containing the label) to the
module end.
6. Using a pair of flat-nosed tweezers, place the tip of the tweezers
beneath the upper right corner of the matching color-coded
module end label. Grasp the corner of the label and lift the label
up and toward you.
7. Carefully align the label to the label indent located on the top of
the module end and apply the label.
8. Repeat steps 3, 4, 5, 6, and 7 for the opposite side of the probe
head and the remaining module end.
2
P6864 High Density Logi c Analyzer Probe Label
34/68 Channel
102/136 Channel
Custom label
Figure 1: Example sheet of P6864 probe labels
3
P6864 High Density Logi c Analyzer Probe Label
C3
C2
A3
CK3
CK0
A2
Module end
P6864
SLOT
A1
A0
CK1
CK2
D0
D1
P6864
SLOT
P6864
SLOT
A1
03217654
Probe head
03217654
CK3
C3
P
6864
SLOT
Figure 2: Attaching the P6864 High Density probe labels
4
Loading...