Tektronix P6434 Mass Termination Probe Field Install Instructions
Instructions
118-9477-01
118-9478-01
118-9487-01
Mictor Connector and Cable Replacement
P6434 Mass Termination Probe
075-0480-00
Warning
The servicing instructions are for use by
qualified personnel only. To avoid personal
injury, do not perform any servicing unless you
are qualified to do so. Refer to all safety
summaries prior to performing service.
Copyright © T ektronix, Inc. All rights reserved.
T ektronix products are covered by U.S. and foreign patents, issued and pending. Information in this publication supercedes
that in all previously published material. Specifications and price change privileges reserved.
Printed in the U.S.A.
T ektronix, Inc., P.O. Box 1000, Wilsonville, OR 97070–1000
TEKTRONIX and TEK are registered trademarks of T ektronix, Inc.
Kit Description
This kit includes parts and instructions to service the P6434 Mass Termination
Probe (see Figure 1). The specific parts included with this kit depend on which
service kit you ordered. See page 2 for part lists of the electrical service kits
available for the P6434 probe. Refer to your manual for mechanical service kit
information.
NOTE. These service kits include upgraded components that require specific
installation procedures that differ from those in the P6434 Instructions, part
numbers 070-9793-00 and -01. If you have either of those versions, you must use
these instructions for servicing your P6434 probe.
Probe tip
Figure 1: P6434 Mass Termination Probe
Minimum Tool and Equipment List
Quantity Description
1 ea Tweezers
2 ea Small, flat-bladed screwdriver
1 ea 0.050 inch hexagonal screwdriver
Module ends
Mictor Connector and Cable Replacement, P6434 Probe
1
Kit Description
Kit Parts List for 118-9477-01
Quantity Part number Description
2 ea NS ELASTOMER CONNECTOR
1 ea NS SP ACER STRIP, PLASTIC
1 ea NS BOARD HOLDER, MOLDED
2 ea NS PULL GRIP HALVES
2 ea NS PULL GRIP CORD
1 ea NS PIN 1 SIDE CABLE WITH CIRCUIT BOARDS
1 ea NS INSTRUCTION, KIT: MICTOR CONNECTOR AND CABLE
NS–Not Saleable
Kit Parts List for 118-9487-01
REPLACEMENT, P6434 PROBE
Quantity Part number Description
2 ea NS ELASTOMER CONNECTOR
1 ea NS SP ACER STRIP, PLASTIC
1 ea NS BOARD HOLDER, MOLDED
2 ea NS PULL GRIP HALVES
2 ea NS PULL GRIP CORD
1 ea NS PIN 38 SIDE CABLE WITH CIRCUIT BOARDS
1 ea NS INSTRUCTION, KIT: MICTOR CONNECTOR AND CABLE
NS–Not Saleable
Kit Parts List for 118-9478-01
Quantity Part number Description
2 ea NS ELASTOMER CONNECTOR
1 ea NS SP ACER STRIP, PLASTIC
1 ea NS BOARD HOLDER, MOLDED
1 ea NS MICTOR CONNECTOR BD WITH MICTOR CONNECT OR
1 ea NS INSTRUCTION, KIT: MICTOR CONNECTOR AND CABLE
REPLACEMENT, P6434 PROBE
REPLACEMENT, P6434 PROBE
NS–Not Saleable
2
Mictor Connector and Cable Replacement, P6434 Probe
Loading...