Tektronix P6330, P7330,,P7350 User manual

P6330, P7330, & P7350
Probe Adapter
Instructions

071-0968-03

*P071096803*

071096803

WARRANTY SUMMARY

Tektronix warrants that the products that it
manufactures and sells will be free from defects in
materials and workmanship for a period of one (1)
year from the date of shipment from an authorized
Tektronix distributor. If a product or CRT proves
defective within the respective period, Tektronix
will provide repair or replacement as described in
the complete warranty statement.

To arrange for service or obtain a copy of the
complete warranty statement, please contact your
nearest Tektronix sales and service office.

EXCEPT AS PROVIDED IN THIS SUMMARY
OR THE APPLICABLE WARRANTY
STATEMENT, TEKTRONIX MAKES NO
WARRANTY OF ANY KIND, EXPRESS OR
IMPLIED, INCLUDING WITHOUT
LIMITATION THE IMPLIED WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR
A PARTICULAR PURPOSE. IN NO EVENT
SHALL TEKTRONIX BE LIABLE FOR
INDIRECT, SPECIAL OR CONSEQUENTIAL
DAMAGES.

Accessory Adapters

Variable spacing adapter (4 ea). The variable spacing

adapter fits over the probe tip. Push the adapter
onto the probe tip until it seats against the probe
head.

Seated

against probe

head

Use the variable spacing adapter to probe any two
adjacent leads or test points spaced between 0.020
and 0.180-inches apart. Adjust the articulated pins
by gently rotating them using a pair of tweezers.

NOTE. The articulated pins are fragile. Use

extreme care when rotating the pins.

The elastomeric contacts inside the adapter are
rated for 50 - 75 insertion cycles with the probe
tip. Replace the adapter after exceeding these
limits to avoid unreliable operation.

Tektronix part number: 016-1885-00
(package of 4)

Square pin adapter (4 ea). Push the square pin adapt-

er onto the probe tip until it seats against the probe
head. Use the square pin adapter to connect the
probe to other accessories, such as the Y -lead
adapter or TwinFoot adapter. The inputs on the
adapter are spaced 0.100-inches apart.

Seated

against probe

head

CAUTION. To avoid damaging the square pin

connectors, do not insert anything larger
than a 0.025-inch square pin into the
inputs.

The elastomeric contacts inside the adapter are
rated for 50 - 75 insertion cycles with the probe
tip. Replace the adapter after exceeding these
limits to avoid unreliable operation.

Tektronix part number: 016-1884-00
(package of 4)

Copyright  Tektronix, Inc.