Tektronix OPTION SSD Installation Manual

xx
Oscilloscope Option SSD
ZZZ
Solid State Drive
Installation
www.tektronix.com
P071285101*
*
Copyright © Tektronix. All rights reserved. Licensed software products are owned by Tektronix or its subsidiaries or suppliers, and are protected by national copyright laws and international treaty provisions.
Tektronix products are covered by U.S. and foreign patents, issued and pending. Information in this publication supersedes that in all previously published material. Specications and price change privileges reserved.
TEKTRONIX and TEK are registered trademarks of Tektronix, Inc.
Contacting Tektronix
Tektronix, Inc. 14150 SW Karl Braun Drive P.O. Box 5 0 0 Beaverto USA
For product information, sales, service, and technical support:
n, OR 97077
In North America, call 1-800-833-9200. Worl dwid e, visi t www.tektronix.com to nd contacts in your area.

Solid State Drive Option

This option provides a solid state drive for the following instrument series:
DPO5000, MSO5000
DPO7000C
DPO70000C, DSA70000C, MSO70000C
Instrumen drive. The solid state drive is faster and more rugged than a standard drive.
For a list your Tektronix representative.
t features are the same with the solid state drive as with the standard
of available options, see the Tektronix Web site (www.tektronix.com) or

Installation Instructions

These instructions are for qualied service personnel who are familiar with servicing the product. If you need further details for disasse mbling or reassembling the product, refer to the appropriate product manual. Contact
earest Tektronix, Inc., Service Center or Tektronix Factory Service for
your n installation assistance.
a properly grounded antistatic strap and use antistatic handling procedures
Wear when removing, installing, and handling the hard drives.
1
Installation Instructions
Removal and Installation
Refer to the gra
1. Power off the instrument.
2. For DPO/MSO5000 instruments, remove the drive cover.
3. Loosen the thumb screw(s) and remove the hard drive as shown.
4. Install the solid state drive as shown, and the n tighten the thumb screws to
secure the drive in the instrument.
5. For DPO/MSO5000 instruments, install the drive cover.
phic when using the following procedure:
2
Loading...