Tektronix MTM4UP FW Field Install Instructions

Instructions

MTM4UP FW
Firmware Upgrade for
MTM400 MPEG Transport Stream Monitor

075-0802-04

Warning

The servicing instructions are for use by qualified
personnel only. To avoid personal injury, do not
perform any servicing unless you are qualified to
do so. Refer to all safety summaries prior to
performing service.

www.tektronix.com

*P075080204*

075080204

Copyright © Tektronix, Inc. All rights reserved. Licensed software products are owned by Tektronix or its subsidiaries or
suppliers, and are protected by national copyright la ws and international treaty provisions.

Tektronix products are covered by U.S. and foreign patents, issued and pending. Information in this publication supercedes
that in all previously published material. Spec ifications and price change privileges reserved.

TEKTRONIX and TEK are registered trademarks of Tektronix, Inc.

Contacting Tektronix

Tektronix, Inc.
14200 SW Karl Braun Drive
P.O. Box 500
Beaverton, OR 97077
USA

For product information, sales, service, and technical support:

H In North America, call 1-800-833-9200.

H Worldwide, visit www.tektronix.com to find contacts in your area.

Kit Description

Products

This document provides instructions for the MTM400 Firmware upgrade kit.

Modifications have been made to the MTM400 firmware; these modifications
also affect the Remote User Interface (RUI).

Installing the WebMSM upgrades ensures compatibility with the MTM400
upgrade.

Overall, the steps required are as follows:

H Check and Upload the MTM400 Firmware.

H Upgrade the WebMSM application (if present).

H Upgrade the WebMSM Configuration Editor application (if present).

The WebMSM applications require a license to enable them. If the applications
were not previously installed, the disks can be discarded.

Serial Number Variants

Kit Parts List

MTM400 MPEG Transport Stream Monitor
WebMSM
WebMSM Configuration Editor

Two variants in the construction of the MTM400 are currently available. They
are differentiated by the format of the serial number. The serial number of each
unit is printed on a label attached to the unit.

Table 1: Serial number formats

GB400--xxxx (Example: GB400--1234)

Bxxxxxx (Example: B010100)

Quantity Part number Description

1EA 063-3719-xx Firmware Pkg, CD-ROM; MTM400 Applications

1EA 075-0802-04 Instructions; MTM4UP FW

MTM4UP FW Firmware Upgrade Instructions

1

Kit Description

2

MTM4UP FW Firmware Upgrade Instructions

Installation Instructions

The procedure is outlined below. Power and networking are required.

1. Power up the MTM400 unit and wait for initialization to complete.

2. From a client PC, open the Remote User Interface.

a. At a networked PC, launch Microsoft Internet Explorer.

b. In the browser address bar, enter the network identity or IP address of the

MTM400 unit, such as http://TSMonitor01.

Press Enter. A Java applet is downloaded from the MTM400 unit and
launched. The file size is approximately 1.5 MB; the download time will
depend on the network speed and traffic.

The MTM400 user interface can also be accessed via the Web Monitoring
Systems Manager (WebMSM). This is described in the WebMSM User Manual.

Upgrading the MTM400 Firmware

Check the Processor

Board Software Version

In the Device View, select Info to display the Device Information screen.

The Device Information view details the software and hardware build state of the
MTM400. (The values shown in this example screenshot will differ from the
values shown on your display.)

Figure 1: Device View - Information

MTM4UP FW Firmware Upgrade Instructions

3