Instructions
K400 Series Accessory Kit
Cable Support and Mouse Shelf
070-9505-01
www.tektronix.com
*P070950501*
070950501
Assembly
To install the mouse shelf, you will use these parts:
H 1 mouse shelf
H 2 weld nuts
H 2 1/4 20 cap head screws, 1/2 inch length
H 2 1/4 inch tooth loc kwashers
Attach the mouse shelf to the cart as follows:
1. Remove the end cap from the post.
2. Loosely install the hardware in the bracket as shown in Figure 1.
3. Slide the nuts into the post, set the bracket to the desired height,
and tighten the screws.
4. Replace the end cap as shown i n Figure 2.
1
Copyright E Tektronix. All rights reserved.
Assembly
Figure 1: Installing the mouse shelf mounting hardware.
K400 Series Accessory Kit Instructions
2
Assembly
Skyhook
(cable support)
384-1800-00
Mouse shelf
436-0317-00
Figure 2: Replacing the end cap (K420 cart shown).
3
K400 Series Accessory Kit Instructions
Assembly
The skyhook (cable support) can be positioned on either side of the
cart. To install the skyhook, you will use these parts:
H 1 sleeve
H 1 adjustment knob
H 1 mount
H 2 weld nuts
H 2 1/4 20 cap head screws, 1/2 inch length
H 2 1/4 inch tooth loc kwashers
H 2 bushings
H 2 grommets
Install the skyhook (cable support) as follows:
1.
Press the two grommets into the large holes on either side of the
keyboard shelf.
2. Install the weld nuts, lockwashers and cap head screws on the
mount as shown in Figure 3. Leave each scre w assembly loose;
do not screw the weld nut onto the cap head screw more than one
full turn
.
3. Prepare the cable support (skyhook) by first pressing the bushings
into the holes in the top and bottom of the mount as shown in
Figure 3. Next place the sleeve on the inside of the mount and
align the sleeve with the openings in the top and bottom of the
mount. Slide the skyhook through the top of the mount and
through the sleeve. Now install the adjustment knob and tighten
lightly to secure the skyhook.
4. Slide the skyhook assembly slowly onto the cart, capturing the
weld nuts in the track. Position where desired and then tighten
with the 3/16 inch Allen Wrench.
5. Set the skyhook (cable support) to the desired height and tighten
the knob.
6. Replace the end cap(s).
K400 Series Accessory Kit Instructions
4
Loading...