Tektronix ITSRACK User manual

ITSRACK Rack mount instructions
Use the following instructions with the illustration and table to assemble the ITSRACK kit.
www.tektronix.com Copyright © Tektronix
*P071305100*
071-3051-00
Item number Quantity Description
1 2 Brac
22
3 2 Bracket assembly, rack, rear mount
44
5
68
7
8 4 Hex nut, 8–32
94
10 8
11 4
12 8
4
4
ket, rack slide, rear mount
Brac
Screw, machine 10-32 x.3/8 inch
#8 Lock washer
#8 Flat washer
Screw, machine, 8–32 x 1/2 inch
Screw, machine, 8–32 x 3/8 inch, at head
Screw, machine, 10–32 x 1/2 inch, pan head, Phillips, with spring lock, 18–8 SS
#10 Washer, 18–8 stainless steel
Clip nut, 10–32 for round holes
ITSRACK Rack mount instructions
1. Remove the scre the front and rear brackets.
2. Install the fr machine screws (item 9).
3. Attach the o the provided hardware (items 5, 6,7, 8). Tighten the screws nger-tight.
4. Install the 10-32 screws (item 4) and #10 stainless steel washers (item 11). Tighten the screws nger-tight.
5. Repeat steps 3 and 4 to as semble and attach the bracket assembly on the other side of the instrument.
6. Install the instrument in the rack, adjusting the rear bracket as required.
a. Note the
b. Tighten the hardware and place the instrument in the rack.
7. Secure the instrument in the rack using the machine screws (item 10) and clip
nuts (item 12) on the front and rear of the rack.
ws from the side of the instrument where you intend to install
ont brackets (item 2) on each side using the 8 x 32 at head
ne of the rear brackets (item 3) to the bracket slide (item 1) using
bracket assembly to the side of the instrument using the
positions of the bracket and remove the instrument from the rack.
2 Rack mount instructions
Loading...