Tektronix ADP-5037 User manual

Model ADP-5037 50-pin
to 37-pin cable adapter
Packing List Manual
Introduction
This document provides safety and installation information for the Keithley ADP-5037 50-pin to 37-pin cable adapter.
Description
You connect the ADP-5037 to an SRA-01 or an ERA-01 via a C1800 or S1800 cable.
Safety summary
WARNING
This product is intended for use by qualified personnel who recognize shock hazards and are familiar with the safety precautions required to avoid possible injury. Read the operating and safety information carefully before using the product.
This accessory is not intended for use in circuits carrying voltages in excess of 30V RMS,
42.4V peak, or 60VDC.
Read and follow the “Safety Precautions” discussed at the end of this manual.
Installation
CAUTION
Figure 1 shows you how to use the ADP-5037 to interface the following boards to an SRA-01 or ERA-01 accessory: the KPCI-PIO96, the PIO-96J, the KPCI-3107, the KPCI-3108, or the KPCI-3160.
Ensure that the computer power is turned OFF before installing the ADP-5037. Con­necting the ADP-5037 to the computer while the power is ON can damage your comput­er, the accessory, or both.
PA-700 Rev. A / 12-99
2
Figure 1
ADP-5037 interface connections
PIO-96J or
KPCI-PIO96 Board
Any of
these
ADP-5037 C-1800
SRA-01
or
ERA-01
KPCI-3107 or KPCI-3108
Board
(Digital I/O Connector)
KPCI-3160 Board
CAB-1284CC STA-3108-D1
CONN-3160-D1
CAB-1800
Any of
these
ADP-5037 C-1800
ADP-5037 C-1800
SRA-01
or
ERA-01
SRA-01
or
ERA-01
Table 1 shows the pin-to-pin correspondence between the 50-pin header connector and the 37-pin D connector of the ADP-5037.
Table 1
Pin-to-pin correspondence between the ADP-5037 connectors
Pins of the 50-pin header
Pins of the 37-pin
Even-numbered pins Odd-numbered pins
D connector
130
331
532
733
934
11 35
13 36
15 37
17 22
19 23
21 24
23 25
25 26
27 27
29 28
31 29
33 3
Loading...
+ 2 hidden pages