Tektronix 2601B-PULSE-CA3 User manual

Model 2601B-PULSE-CA3 Cable Kit

1

Keithley Instruments

28775 Aurora Road
Cleveland, Ohio 44139
1-800-833-9200

tek.com/keithley

Instructions

Description

The Keithley Instruments 2601B-PULSE-CA3 BNC-to-BNC Cable Kit includes two 3.0 m 15 Ω low-inductance
cables. The 2601B-PULSE-CA3 is intended to make the FORCE HI and LO connections for a 4-wire
measurement. On the end intended for connection to the device under test (DUT), the shields are jumpered to
reduce loop inductance.

The SENSE HI and SENSE LO connections are made using the 2601B-PULSE-CA2 BNC-to-BNC Coaxial
Cables (sold separately).

This cable kit is intended for use with the Model 2601B-PULSE System SourceMeter® instrument with the
2601B-P-INT Interlock and Cable Connector Box installed.

Figure 1: Model 2601B-PULSE-CA3 Cable Kit

077169000 April 2020

*P077169000*

Model 2601B-PULSE-CA3 Cable Kit Instructions

2

Characteristics

Rated voltage and current: 40 V maximum, 11 A
Operating environment: −55 °C to +200 °C
Characteristic impedance: 15 Ω
Loop DC resistance*: 100 mΩ
Loop inductance at 100 kHz*: 700 nH
Individual cable diameter: 2.5 mm (0.10 in.)
Jumper length: 152 mm (6.0 in.)

* Measured using a 2601B-PULSE System SourceMeter® instrument with the 2601B-P-INT Interlock and Cable
Connector Box installed and with center conductors (FORCE HI and FORCE LO) shorted together at the
DUT end.

077169000 April 2020