Tektronix 2600-TLINK User manual
Model 2600-TLINK
Keithley Instruments, Inc.
28775 Aurora Road
Cleveland, Ohio 44139
(440) 248-0400
www.keithley.com
Digital I/O to TLink Adapter Cable
Introduction
This document contains information on the Model 2600-TLINK Digital I/O to TLink adapter cable. Use this
cable to connect the Model 260 x SourceMeter
®
Instrument trigger link to digital I/O.
Cable description
As shown in Figure 1, the length of the cable is 3 feet. One connector is an 8-pin locking Micro-din
connector, and the other connector is a 25 Pin D-Sub connector. Figure 2 contains the connector pinouts.
Table 1
Cable specifications
Characteristic Range/Value Specification
Shield effectiveness (minimum)
Temperature range Operating -20° to 80°C
Voltage rating Peak 42V
Amperage rating Maximum 1.0 Amp
Figure 1
Cable features
3 feet
8 Pin Male Micro-din
Connector (Locking)
70–500MHZ
500–1000MHZ
25 Pin D-Sub
Connector (Male)
20dB
10dB
PA-906 Rev. A / 04-05
2
WARNING:
NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.
WARNING:
NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.
CAUTION:
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING.
CAUTION:
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING.
Figure 2
Cable pinouts
Schematic
6
3
4
1
7
2
5
8
1
2
3
4
5
6
7
8
NC
NC
NC
NC
NC
NC
NC
NC
1
2
3
4
5
6
7
8
9
10
11
12
13
14
13
25
15
16
17
18
1
14
19
NC
NC
NC
NC
NC
NC
20
21
22
23
24
25
Connection
Refer to Figure 3 for the typical instrument connector location. Refer to the specific instrument’s User’s
Manual for additional connection information.
WARNING Do not exceed the voltage rating for this cable. This cable is intended
for use to transfer digital I/O information as a trigger link and is not
intended as a power supply. Make sure both connections do not exceed the cables specifications.
Failure to follow this warning may result in injury from electrical
shock as well as damage to the equipment.
Figure 3
Typical instrument connector
CHANNEL A
SS
CAT I
US
LO LO HIHI GGGG
LINE FUSE
SLOWBLOW
!
RS-232
3.15A, 250V
R
!
LINE RATING
100-240VAC
50, 60Hz
240VA MAX.
Model 2602 Digital I/O connection
(25-pin D-sub Female)
G
HI
G
G
S
HI
CAT I
CHANNEL B
DIGITAL I/O
IEEE-488
(CHANGE IEEE ADDRESS
WITH FRONT PANEL MENU)
U
L
C
LISTED
SourceMeter
!
4ZA4
TSP-Link
S
LO
G
LO
!
MADE IN
U.S.A.
Loading...