Tektronix 2510, 2510-AT User manual

WARNING:NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.

WARNING:NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.

CAUTION:FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING.

CAUTION:FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING.

Models 2510 and 2510-AT Connector Label

Keithley Instruments, Inc.

28775 Aurora Road
Cleveland, Ohio 44139
[phone]

Packing List

Introduction

This packing list contains information about the supplied INPUT/OUTPUT connector label, which can be used to properly
identify OUTPUT connection polarity when using the Model 2510/2510-AT with certain TECs.

Output current convention

The Models 2510 and 2510-AT assume that a positive output current is heating current. Ho wever, industry con v ention is that a
positive TEC current is a cooling current. F or proper operation with such TECs, it is recommended that you install the supplied
label and reverse TEC connections as discussed below.

Label installation

T o install the label, remo ve the backing and then install the label immediately abo ve the INPUT/OUTPUT connector as sho wn
in Figure 1 below. Be sure to position the label so that the terminals are correctly identified.

TEC connections

For positive TEC current cooling convention, connect the TEC positiv e terminal to the OUTPUT TEC+ terminal sho wn on the
label (and OUTPUT S+ terminal when using 4-wire connections). Connect the TEC negative terminal to the OUTPUT TEC­terminal (and OUTPUT S- terminal when using 4-wire connections).

Figure 1

INPUT/OUTPUT label installation

OUTPUT

TEC- S- S+ TEC+

ISOLATION FROM EARTH: 30V MAX.

Install Label Above
INPUT/OUTPUT
Connector

INPUT

F+ F- S+ S-

CAT I

!

OUTPUT INPUT

F+ S+ S- F- F+ F- S+ S-

ISOLATION FROM EARTH: 30V MAX.

MADE IN

U.S.A.

TRIGGER

LINK

ENABLE-DIG I/O

LINE FUSE

SLOWBLOW

2.5A, 250V

!

LINE RATING

100-240VAC

50, 60 HZ
90VA MAX

RS-232

120

Model 2510/2510-AT

IEEE-488

(ENTER IEEE ADDRESS

WITH FRONT PANEL MENU)

PA-791 Rev. A / 5-01

2