Tektronix 119-7900-00 AC Adapter/Power Supply User manual
xx
119-7900-xx
THS3000 Series Oscilloscopes
AC Adapter/Power Supply
ZZZ
Instructions
Description
The 119-7900-xx AC Adapter is for use with THS3000 Series
handheld oscilloscopes. It is also used with the THSCHG
battery charging base to charge the THSBAT Li-ion battery
packs.
Refer to the THSBAT Rechargeable Battery Pack
NOTE.
Instructions (Tektronix part number 071-2960-xx) for
information on storage, transportation, and end-of-life
recycling or disposal of the THSBAT Lithium-Ion battery pack.
Table 1: Power cord options
Country of use Tektronix part number
North America (Option A0)
Universal Euro (Option A1)
United Kingdom (Option A2)
Australia (Option A3)
Switzerland (Option A5)
Japan (Option A6)
China (Option A10)
India (Option A11)
Brazil (Option A12)
Universal Euro & UK (Option E1) 161-0066-09 & 161-0066-10
161-0066-00
161-0066-09
161-0066-10
161-0066-13
161-0154-00
161-0298-00
161-0304-00
161-0400-00
161-0357-00
Specifications
Characteristic Description
Line frequency 50/60 Hz ±5%
Input voltage
Input current
Output voltage 18 VDC ±5%
Output current
Output connector
Operating temperature 0 °C to +50 °C (+32 °F to +122 °F)
Altitude
Humidity
Pollution Degree Pollution Degree 2
100–240 VAC ±10%
350 mA @ maximum load
840 mA
5 mm, – to center pin, + to outer contact
2000 m (6562 ft)
80%upto31°C(88°F)
Safety Summary
To avoid potential hazards, use this product only as specified.
To Avoid Fire or Personal Injury
Recharge battery properly.
for the recommended charge cycle at the recommended
temperature.
Use Proper Power Cord.
this product and certified for the country of use.
Ground the Product.
grounding conductor of the power cord. To avoid electric
shock, the grounding conductor must be connected to earth
ground. Before making connections to the input or output
terminals of the product, ensure that the product is properly
grounded.
Power Disconnect.
from the power source. Do not block the power cord; it must
remain accessible to the user at all times.
Recharge the battery pack only
Use only the power cord specified for
This product is grounded through the
The power cord disconnects the product
*P071296200*
071-2962-00
x
Use proper battery charger.
Use only the THSCHG charger
or the THS3000 series oscilloscope to charge the THSBAT
Lithium-Ion battery pack.
Do not operate without covers.
Do not operate this product
with covers or panels removed.
Do not operate with suspected failures.
If you suspect there is
damage to this product, have it inspected by qualified service
personnel.
Do not operate in wet/damp conditions.
Keep product surfaces clean and dry.
Safety Terms in This Manual
CAUTION.
These statements identify conditions or practices
that could result in damage to the equipment or other
property.
Safety Symbols on the Product
This symbol indicates that this product complies
with the applicable European Union requirements
according to Directives 2002/96/EC and 2006/66/EC
on waste electrical and electronic equipment
(WEEE) and batteries. For information about
recycling options, check the Support/Service section
oftheTektronixWebsite(www.tektronix.com).
Warranty Information
For warranty information, go to the www.tektronix.com Web
site, and search for “THS warranty”.
Contacting Tektronix
Tektronix, Inc.
14200 SW Karl Braun Drive
P.O. Box 500
Beaverton, OR 97077
USA
For product information, sales, service, and technical support:
In North America, call 1–800–833–9200.
Worldwide, visit www.tektronix.com to find contacts in
your area.
Copyright © Tektronix, Inc. All rights reserved. www.tektronix.com
Loading...