Tektos Qimini pocket User Manual

User Manual.

Wireless Charging Station for Qi-enabled devices.

Safety Instructions

We do not assume liability for resulting
damages to property or personal injury if
the product has been abused in any way
or damaged by improper use or failure to
observe these operating instructions. The
warranty/guarantee will then expire.

• The product is not a toy and should be kept out
of reach of children.

• Using an USB port on a notebook or other
device might result in a less satisfying user
experience.

• Do not subject the unit to excessive force,
shock, dust, temperature or humidity.

• Do not immerse the unit in water. If you spill
liquid over it, dry it immediately with a soft,
lint-free cloth.

• Do not clean the unit with abrasive or corrosive
materials.

• Do not tamper with the unit’s internal compo­nents. This invalidates the warranty.

• If there is reason to believe that safe operation
is no longer possible, the device is to be put out
of operation and secured against unintended
operation. Safe operation is no longer possible
if the device:

- no longer works

- shows visible damages

- was stored under unfavourable conditions for
a long period of time

- was subject to considerable transport stress

• When disposing of this product, ensure it is
collected separately for special treatment and not
as normal household waste.

• Repair works must only be carried out by a
specialist / workshop.

• Images shown in this manual may differ from
the actual display.

• The contents of this manual may not be
reproduced without the permission of the
manufacturer.

EN

Content

This pack contains one Qimini™ Pocket.

1. Plug the male USB of the Qimini™ into a 5V
AC/DC adaptor or into any computer’s USB
port. For optimal performance, we recommend
to use a 5V USB port able to provide up to 2A.

2. Place any Qi-enabled device on the
Qimini™. You are ready to charge your device.

Instructions

Trademark

Qimini™ is a trademark of Tektos Ltd registered in Hong Kong and other countries.

Disposal

Disposal of waste electrical and electronic
equipment.

In order to preserve, protect and improve
the quality of the environment, protect
human health and utilise natural resources
prudently and rationally, the user should return
unserviceable product to relevant facilities in
accordance with statutory regulations.

The crossed-out wheeled bin indicates the
product needs to be disposed separately and
not as municipal waste.

EU Declaration of Conformity

FCC Compliance Statement

Hereby, Tektos Limited, declares that the
provided Wireless Charger Station (Model:
QIMP0B is in conformity with the requirements
of Directive 1999/5/EC.

A copy of the signed and dated Declaration of
Conformity is available on request.

Changes or modications not expressly appro­ved by the party responsible for compliance
could void the user’s authority to operate the
equipment.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a resi­dential installation. This equipment generates,
uses and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interfe­rence to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equip­ment and receiver.

-- Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.

-- Consult the dealer or an experienced radio/TV
technician for help.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harm­ful interference, and (2) this device must accept
any interference received, including interference
that may cause undesired operation.

This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed
and operated with a minimum distance of 20cm
between the radiator & your body. This transmit­ter must not be co-located or operating in
conjunction with any other antenna or
transmitter.

Warning

Maintenance

To reduce the risk of interference with other electrical equipment:

- Consult your doctor or device manufacturer if you have a pacemaker or other implanted electrical device.

- Do not place your phone on the charger and plug it into the USB port simultaneously.

When a product interferes with Qimini Pocket, please disconnect the USB plug.

No software update needed.

myqimini.com