Tedan STANDARD MB 80, PRAKTIK MB 50, PRAKTIK MB 80, PRAKTIK MB 100, PRAKTIK MB 120 Installation, Use And Care Manual
...
INSTRUCTIONS FOR INSTALLATION, USE AND CARE OF WATER HEATERS
STANDARD MB 30, 50, 80 lit. STANDARD MB 80 H,
PRAKTIK MB 50, 80, 100, 120 lit. PRAKTIK MB 50, 80, 100, 120 lit. Inox
PRAKTIK MB PK 80,120 lit. PRAKTIK MB PK 80, 120 lit. Inox
SLIM MB 30, 50, 80 lit. SLIM MB 30, 50, 80 lit. Inox
2
EN
CONTENTS
Technical information.....................................................................3
Installation......................................................................................4
Connection to water supply............................................................8
Connection to power supply...........................................................9
Use, control and maintenace of electrical water heaters.............10
Waste disposal ............................................................................11
3
EN
pic.1
1. Housing
2. Polyurethane insulation
3. Heating tank (enamelled)
4. Screw, seal, nut, washer
5. Heater with seal
6. Flange
7. Flange sealing rubber
8. Counter-ange
9. Thermoregulator
10. Mg-anode
11. Connection tube for water
12. Rings
13. Connection tube for hot water
output
14. Signal lamp
15. Thermoregulator button
16. Thermometer
17. Support for hanging to wall
18. Screws for support
TECHNICAL INFORMATION
Electrical accumulation water heaters are designed to work with pressure of
the water supply pipeline. The appliance is not meant for persons (including
children) of reduced psychophysical abilities, unless under supervision of
persons responsable for their safety, i.e. for persons not skilled for use of the
appliance. Improper use of the appliance, especially from the side of children,
should be prevented.
Water heaters are made according to valid standards and tested and certied by
authorized laboratory. Product technical characteristics are given on the sticker
„Table with Characteristics“ between connection pipes.
Picture 1 shows design of the water heater with all parts
4
EN
INSTALLATION
Only authorized persons are allowed to perform installation / connection of water
heaters to water and power supplies. All types of water heaters are xed to the
wall by 2 or 4 screws of 8 mm minimum diameter. Thin and delicate walls should
be reinforced prior to water heater installation
Technical characteristics of accumulation water heater:
Model Standard MB 30 Standard MB 50 Standard MB 80
Capacity (litres) 30 50 80
Weight when full of
water (kg)
0.6 0.6 0.6
Weight when full of
water (kg)
17/47 22/72 29/109
Corrosion
protection
type
Enamelled Mg
anode
Enamelled Mg
anode
Enamelled Mg
anode
Heater power (W) 2000 2000 2000
Voltage 230 230 230
Time of water
heating from 15°C
to 75°C
1
05
1
55
3
05
Model Praktik MB 80 Praktik MB 100 Praktik MB 120
Capacity (litres) 80 100 120
Weight when full of
water (kg)
0.6 0.6 0.6
Weight when full of
water (kg)
28/108 32/132 36/156
Corrosion
protection
type
Enamelled Mg
anode
Enamelled Mg
anode
Enamelled Mg
anode
Heater power (W) 2000 2000 2000
Voltage 230 230 230
Time of water
heating from 15°C
to 75°C
2
55
3
50
4
35
Loading...