14 28277Washer, Flat
15 30589Rod, Governor (Incl. 14)
16 31383ALever, Governor
17 31335Clamp, Governor lever
18 650548Screw, 8-32 x 5/16"
19 33578Spring, Governor
20 32600Seal, Oil
30 34575Crankshaft
32 32323Washer, Thrust NOTE: This thrust washer maynot be
required if a new crankshafthas been installed. Check the
proper Mechanic's Handbook for acceptable end play. Use
this .010" thrust washer if excess end play is measured.
40 34851Piston, Pin & Ring Set (Std.) (2-5/8" Bore) NOTE: These
piston, pin andring sets and pistons have been superceded
into a new piston, pin and ring set assembly. As of this
update the ring sets (34854, 34855, 34856) are stillavailable.
It will be necessary to note on the engine that the piston, pin
238 650835Screw, 10-32 x 9/16"
239A 35815Gasket, Air cleaner
242A 34929Bracket, Air cleaner support
245D 32796Filter, Air cleaner
246E 35435Filter, Pre-air (Use as required)
247A 33143Clamp, Air cleaner
247B 34930Retainer, Air cleaner
248C 33142Tube, Air intake
261 30200Screw, 10-24 x 9/16"
www.mymowerparts.com
For Discount Tecumseh Engine Parts Call 606-678-9623 or 606-561-4983
TVXL105-54020BPage 4 of 8
Engine Parts List #1
Ref # Part NumberQty Description
262 650831Screw, 1/4-20 x 15/32"
277 650795Screw, 1/4-20 x 2-1/4" (Use as requir ed)
277 650774Screw, 1/4-20 x 2-3/8" (Use as requir ed)
277 792005Screw, 1/4-20 x 2-1/2" (Use as requir ed)
285 35000Hub, Starter
286 34999Screen, Starter cup
290 34357Fuel Line (Epichlorohydrin 6-3/4")(17 cm)
290 29774Fuel Line(Braided 8-1/4")(21 cm)(Use as req.)
290 30705Fuel Line (Braided 16")(40 cm)(Use as req.)
290 30962Fuel Line (Braided 32")(81 cm)(Use as req.)
292 26460Clamp, Fuel line
301 33032Fuel Cap (Use as required)
305 34264Oil Fill Tube
306 34265Gasket, Oil fill tube
306 34282"O" Ring (This "O" ring is required with metal fill tube only
when replacement mounting flange with .777 dia. oil fill hole
has been used.)
307 33590"O" Ring
309 650562Screw, 10-32 x 1/2"
310 34267Oil Dipstick (Incl. 150)
313 34080Spacer, Flywheel key
325 29443Clip, Fuel line
354 35025Staple (Not used on all models)
370A 35004Decal, Instruction
370J 34870Decal, Instruction (Optional)
370H 34387Decal, Instruction (Optional)
379 631021Inlet Needle, Seat & Clip Assy.
380 632252Carburetor (Incl. 184) (Refer to Division 5, Section A, page
A1-14 or Fiche 8A, Grid E-1 for breakdown)
390 590557Rewind Starter (Refer to Division 5, Section C, Page 25 or
For Discount Tecumseh Engine Parts Call 606-678-9623 or 606-561-4983
TVXL105-54020BPage 5 of 8
Engine Parts List #2
www.mymowerparts.com
For Discount Tecumseh Engine Parts Call 606-678-9623 or 606-561-4983
TVXL105-54020BPage 6 of 8
Engine Parts List #2
Ref # Part NumberQty Description
12A 34695Elbow, Breather tube
32 32323Washer, Thrust NOTE: This thrust washer maynot be
required if a new crankshafthas been installed. Check the
proper Mechanic's Handbook for acceptable end play. Use
this .010" thrust washer if excess end play is measured.
71 34837Bushing, Flange
104 34836Bushing, Cylinder
118 730194Rope Guide Kit (Use as required)
167 650688Screw, 10-32 x 1" (Drilled thru)
168 32924Spring, Speed adjusting screw
201 33150Bracket, Over-ride
237 32971Adapter, Air cleaner
238 650835Screw, 10-32 x 9/16"
239A 35815Gasket, Air cleaner
242A 34929Bracket, Air cleaner support
245D 32796Filter, Air cleaner
246E 35435Filter, Pre-air (Use as required)
247A 33143Clamp, Air cleaner
247B 34930Retainer, Air cleaner
248C 33142Tube, Air intake
260A 35003Housing, Blower
286 34999Screen, Starter cup
287A 650735Screw, 10-24 x 3/8" (Use as required)
287APop Rivet (3/16" Dia.) (Purchase loca lly)
354 35025Staple (Not used on all models)
357 34985Rope Stop & Staple Assy. (Incl. 354)
358 34372ABracket Assy., Rope guide
For Discount Tecumseh Engine Parts Call 606-678-9623 or 606-561-4983
TVXL105-54020BPage 7 of 8
Engine Parts List #3
www.mymowerparts.com
For Discount Tecumseh Engine Parts Call 606-678-9623 or 606-561-4983
TVXL105-54020BPage 8 of 8
Engine Parts List #3
Ref # Part NumberQty Description
12A 34695Elbow, Breather tube
19 33578Spring, Governor
32 32323Washer, Thrust NOTE: This thrust washer maynot be
required if a new crankshafthas been installed. Check the
proper Mechanic's Handbook for acceptable end play. Use
this .010" thrust washer if excess end play is measured.
69 35261* Gasket, Mounting flange
71 34837Bushing, Flange
104 34836Bushing, Cylinder
118 730194Rope Guide Kit (Use as required)
167 650688Screw, 10-32 x 1" (Drilled thru)
168 32924Spring, Speed adjusting screw
182 6201Screw, 1/4-28 x 7/8"
185 33004APipe, Intake (Incl. 224)
186 34358Link, Governor spring
201 33150Bracket, Over-ride
206 610973Terminal (Use as required)
209 30200Screw, 10-24 x 9/16"
223 650451Screw, 1/4-20 x 1"
238 650835Screw, 10-32 x 9/16"
239A 35815Gasket, Air cleaner
242A 34929Bracket, Air cleaner support
245D 32796Filter, Air cleaner
246E 35435Filter, Pre-air (Use as required)
247B 34930Retainer, Air cleaner
247A 33143Clamp, Air cleaner
248C 33142Tube, Air intake
274 26754A* Gasket, Exhaust (Use as required)
275A 34613Muffler
276 33753Plate, Locking
277 650795Screw, 1/4-20 x 2-1/4" (Use as requir ed)
277 650774Screw, 1/4-20 x 2-3/8" (Use as requir ed)
277 792005Screw, 1/4-20 x 2-1/2" (Use as requir ed)
277A 30063Screw, Torx T-30, 1/4-20 x 1/2" (Use as req.)
286 34999Screen, Starter cup
354 35025Staple (Not used on all models)