100 35135Lamination Assy., Solid State
102 650872Stud, Lamination mounting
103 650814Screw, Torx T-15, 10-24 x 1"
www.mymowerparts.com
For Discount Tecumseh Engine Parts Call 606-678-9623 or 606-561-4983
HM80-155405MPage 3 of 10
Engine Parts List #1
Ref # Part NumberQty Description
110 35253Ground Wire
119 34041A* Gasket, Head
120 34030AHead, Cylinder
125 27878AExhaust Valve (Std.) (Incl. 151)
125 27880AExhaust Valve (1/32" OS) (Incl. 151)
126 34035Intake Valve (Std.) (Incl. 151)
126 34036Intake Valve (1/32" OS) (Incl. 151)
127 650691Washer (Use as req., but not w/6021A screw)
128 650690Washer, Belleville
129 650727Screw, 5/16-18 x 1-3/4" (Use as requi red)
130 650694AScrew, 5/16-18 x 2" (Use as required)
130A 6021AScrew, 5/16-18 x 1-1/2" (Use as req.,but not w/650691
washer)
131A 650713Screw, 5/16-18 x 5/8" (Use as require d)
139 33369Bracket, Governor gear
140 650836Screw, 10-24 x 1/2"
149 27882Cap, Upper valve spring
149A 27882Cap, Upper valve spring
149A 35862Seal Assy., Intake valve
150 27881Spring, Valve
151 32581Cap, Lower valve spring
169 27896A* Gasket, Breather cover
170 28423Body, Breather
171 28424Element, Breather
172 28425Cover, Valve spring
173 35350Tube, Breather
178 29752Nut & Lockwasher, 1/4-28
182 30088AScrew, 1/4-28 x 1"
184 33263* Gasket, Carburetor
185 33877Pipe, Intake
203 31342Spring, Compression
204 650549Screw, 5-40 x 7/16"
206 610973Terminal Assy. (Use as required)
207 33878Link, Governor-to-throttle
209 650821Screw, 10-32 x 1/2"
211 28820Screw, 10-32 x 1/2"
223 650378Screw, Torx T-30, 5/16-18 x 1-1/8"
224 27915A* Gasket, Intake pipe
242 33267Bracket, Air cleaner
260 33375DBlower Housing (For electric starter)
261 650788Screw, 5/16-18 x 3/4"
262 29747BScrew, 5/16-24 x 21/32"
265 33272BCover, Cylinder head
275 33280AMuffler
276 35740Plate, Muffler locking
277 650729Screw, 5/16-18 x 3-3/16"
285 35985Cup, Starter
286 35446Screen, Starter (Stationary)
287 29752Nut & Lockwasher, 1/4-28
290 30962Fuel Line (Braided 32") (81 cm)
292 26460Clamp, Fuel line
298 650665Screw, 1/4-15 x 7/8"
300 34186AFuel Tank (Incl. 292 & 301) NOTE: These tanks were
builtwith different size fuel inlet openings. Tanks with the
1-3/16" I.D. opening use fuel cap 34210. Tanks with the
1-1/2" I.D. opening use fuel cap 35355.
301 35650Fuel Cap
www.mymowerparts.com
For Discount Tecumseh Engine Parts Call 606-678-9623 or 606-561-4983
HM80-155405MPage 4 of 10
Engine Parts List #1
Ref # Part NumberQty Description
310A 35941Dipstick (Incl. 306)
311 27625Plug, Oil fill (Incl. 312)
312 29673* Gasket, Oil fill plug
325 34246Clip, Ground wire (Use as required)
325B 29443Clip, Fuel line (Use as required)
327 35392Plug, Starter
329 610973Terminal Assy.
330 34069Wire Harness (6-3/4") (7 Amp)
337 35057ACover, Carburetor
340 34154Plate, Fuel tank mounting
342 650561Screw, 1/4-20 x 5/8"
361 650820Screw, 1/4-20 x 1/2"
361A 30063Screw, Torx T-30, 1/4-20 x 1/2"
370A 34686Decal, Name
370 34346Decal, Instruction
370 35274Decal, Instruction
370J 34870Decal, Instruction Can be used on HM80 with diecast starter.
370B 34387Decal, Instruction Can be used on HM80 with stamped steel
recoil starter.
379 631021Inlet Needle, Seat & Clip Assy.
380 632351Carburetor (Incl. 184) (Refer to Division 5, Section A, page
A3-14 for breakdown or Fiche 18A-2, Grid F-7)
390A 590671Rewind Starter (Refer to Division 5, Section C, page 37 for
breakdown or Fiche 18A-2, Grid G-2)
395 35763AElectric Starter Motor (12 Volt) (Refer to service number
stamped on end cap of motor, or on decal, for identification.
Refer to Division 5, Section D, for breakdown or Fiche 18A-2,
Grids G-4, G-5 or G-6)