276 31588Plate, Muffler locking
276 35741Plate, Muffler locking
277 650729Screw, 5/16-18 x 3-3/16" (Use as requ ired)
277 651002Screw, 5/16-18 x 4-1/4" (Use as requi red)
285 35287Cup, Starter
286 35446Screen, Starter
287 29752Nut, 1/4-28
290 29774Fuel Line (Braided 8-1/4")(21cm)(As r equired)
290 30962Fuel Line (Braided 32")(80cm)(As requ ired)
291 30705Fuel Line (Braided 16")(40cm)(As requ ired)
292 26460Fuel Line Clamp (Use as required)
294 35791Fuel Pump Repair Kit NOTE: 34385 and 33715 (WIP)pumps
are replaced by 35813 and 35800 (WIP) pumps. The 33010
(3000 series) repair kit is still available. The 35791 repair kit
is used with the 35813 and 35800 fuel pumps.
295 32961Valve, Fuel shut-off
298 650665Screw, 1/4-15 x 7/8"
300 34156AFuel Tank (Incl. 292 & 301) NOTE: These tanks were
builtwith different size fuel inlet openings. Tanks with the
1-3/16" I.D. opening use fuel cap 34210. Tanks with the
1-1/2" I.D. opening use fuel cap 35355.
301A 410144BFuel Cap (White Plastic)(Standard) (Use as required) (1.5"
I.D.)
301A 33032Fuel Cap (Red Plastic) (Spurt Resistant, Low Profile) (Use as
required) (1.5" I.D.)
301A 34210Fuel Cap (Red Plastic) (Spurt Resistant, High Profile) (Use
as required) (1.5" I.D.)
305 33893AOil Fill Tube
307 33590"O" Ring
310 34011ADipstick (Incl. 307)
325A 29443Clip, Fuel line
327 35392Plug, Starter
336 650765Screw, 10-32 x 1/2"
337 35057ACover, Carburetor (Incl. 329)
338 28942Screw, Sems 10-32 x 3/8"
338A 31291Plug, Cover
340 34154Plate, Upper fuel tank mtg.
341 34155Bracket, Lower fuel tank mtg.
342 650561Screw, 1/4-20 x 5/8"
350 570682Primer Assy.
351 32180CLine, Primer
356 650168Washer
361 30063Screw, Torx T-30, 1/4-20 x 1/2"
364 33377Bracket, Carburetor cover mtg.
365 650767Screw, 8-32 x 27/64"
www.mymowerparts.com
For Discount Tecumseh Engine Parts Call 606-678-9623 or 606-561-4983
HM100-159129LPage 5 of 9
Engine Parts List #1
Ref # Part NumberQty Description
370D 34144Decal, Primer
379 631021Inlet Needle, Seat & Clip Assy.
380 632370Carburetor (Incl. 184 & 379) (Refer to Division 5, Section A,
page 200 for breakdown or Fiche18B, Grid E-13)
390 590630Rewind Starter (Refer to Division 5, Section C, page 30 for
breakdown or Fiche 18B, Grid G-1)
395 33329DStarter Motor Kit (110-120 Volt) This 110-120 volt starter
motor kit may have been added to this engine. It can be
added only if cylinder hasdrilled and tapped starter mounting
bosses and a ring gear flywheel. Refer to service number
stamped on end cap of motor or on decal for I.D. Use only
610847
277 650729Screw, 5/16-18 x 3-3/16" (Use as requ ired)
277 651002Screw, 5/16-18 x 4-1/4" (Use as requi red)
290 29774Fuel Line (Braided 8-1/4")(21cm)(As r equired)
290 30962Fuel Line (Braided 32")(80cm)(As requ ired)
291 30705Fuel Line (Braided 16")(40cm)(As requ ired)
293 33715Impulse Fuel Pump NOTE: 34385 and 33715 (WIP)pumps
are replaced by 35813 and 35800 (WIP) pumps. The 33010
(3000 series) repair kit is still available. The 35791 repair kit
is used with the 35813 and 35800 fuel pumps.
298 650665Screw, 1/4-15 x 7/8"
301A 410144BFuel Cap (White Plastic)(Standard) (Use as required) (1.5"
I.D.)
301A 33032Fuel Cap (Red Plastic) (Spurt Resistant, Low Profile) (Use as
required) (1.5" I.D.)
301A 34210Fuel Cap (Red Plastic) (Spurt Resistant, High Profile) (Use
as required) (1.5" I.D.)
303 32958Fitting, Fuel
337 35057ACover, Carburetor (Incl. 329)
338A 31291Plug, Cover
370D 34144Decal, Primer
370E 34414Decal, Warning