260 33375DBlower Housing (For electric starter)
261 650788Screw, 5/16-18 x 3/4"
262 29747BScrew, 5/16-24 x 21/32"
265 33272BCover, Cylinder head
276 35741Plate, Muffler locking
277 650729Screw, 5/16-18 x 3-3/16" (Use as requ ired)
277 651002Screw, 5/16-18 x 4-1/4" (Use as requi red)
285 32125Cup, Starter
286 35194Screen, Starter
www.mymowerparts.com
Page 4
For Discount Tecumseh Engine Parts Call 606-678-9623 or 606-561-4983
HM100-159014DPage 4 of 10
Engine Parts List #1
Ref # Part NumberQty Description
287 29752Nut, 1/4-28
290 29774Fuel Line (Braided 8-1/4")(21cm)(As r equired)
290 30962Fuel Line (Braided 32")(80cm)(As requ ired)
291 30705Fuel Line (Braided 16")(40cm)(As requ ired)
292 26460Fuel Line Clamp (Use as required)
298 650665Screw, 1/4-15 x 7/8"
300 34156AFuel Tank (Incl. 292 & 301) NOTE: These tanks were
builtwith different size fuel inlet openings. Tanks with the
1-3/16" I.D. opening use fuel cap 34210. Tanks with the
1-1/2" I.D. opening use fuel cap 35355.
301A 410144BFuel Cap (White Plastic)(Standard) (Use as required) (1.5"
I.D.)
301A 33032Fuel Cap (Red Plastic) (Spurt Resistant, Low Profile) (Use as
required) (1.5" I.D.)
301A 34210Fuel Cap (Red Plastic) (Spurt Resistant, High Profile) (Use
as required) (1.5" I.D.)
301A 35355Fuel Cap (Red Plastic)(1.75" I.D.)
305 33951AOil Fill Tube
307 33590"O" Ring
310 34122ADipstick (Incl. 307)
311 27625Oil Fill Plug (Incl. 312)
312 29673* Gasket, Oil filler plug
325 34246Clip, Ground wire
338A 31291Plug, Cover
340 34154Plate, Upper fuel tank mtg.
341 34155Bracket, Lower fuel tank mtg.
342 650561Screw, 1/4-20 x 5/8"
361 30063Screw, Torx T-30, 1/4-20 x 1/2"
370 35274Decal, Instruction
379 631021Inlet Needle, Seat & Clip Assy.
380 632255Carburetor (Incl. 184 & 379) (Refer to Division 5, Section A,
page A4-4 for breakdown or Fiche 18B, Grid D-3)
395 35763AElectric Starter Motor (12 Volt) (Refer to service number
stamped on end cap of motor, or on decal, for identification.
Refer to Division 5, Section D for breakdown or Fiche 18B,
Grid G-6)
For Discount Tecumseh Engine Parts Call 606-678-9623 or 606-561-4983
HM100-159014DPage 5 of 10
Engine Parts List #2
www.mymowerparts.com
Page 6
For Discount Tecumseh Engine Parts Call 606-678-9623 or 606-561-4983
HM100-159014DPage 6 of 10
Engine Parts List #2
Ref # Part NumberQty Description
37A 30322Nut & Lockwasher, 8-32
62 650760Screw, 8-32 x 3/8"
63 28545Grommet, Plastic
68 33356Tab, Ground terminal
129 650727Screw, 5/16-18 x 1-3/4 (Use as requir ed)
131 650737Screw, 1/4-20 x 1/2" (Use as required )
131 650738Screw, 1/4-20 x 5/8 (Use as required)
131A 650713Screw, 5/16-18 x 5/8"
222APop Rivet (Can be purchased locally)
250B 33269ACover, Air cleaner
274 35865Gasket, Exhaust
277 650729Screw, 5/16-18 x 3-3/16" (Use as requ ired)
277 651002Screw, 5/16-18 x 4-1/4" (Use as requi red)
290 29774Fuel Line (Braided 8-1/4")(21cm)(As r equired)
290 30962Fuel Line (Braided 32")(80cm)(As requ ired)
292 26460Fuel Line Clamp (Use as required)
298 650665Screw, 1/4-15 x 7/8"
300 34156AFuel Tank (Incl. 292 & 301) NOTE: These tanks were
builtwith different size fuel inlet openings. Tanks with the
1-3/16" I.D. opening use fuel cap 34210. Tanks with the
1-1/2" I.D. opening use fuel cap 35355.
301A 410144BFuel Cap (White Plastic)(Standard) (Use as required) (1.5"
I.D.)
301A 33032Fuel Cap (Red Plastic) (Spurt Resistant, Low Profile) (Use as
required) (1.5" I.D.)
301A 34210Fuel Cap (Red Plastic) (Spurt Resistant, High Profile) (Use
as required) (1.5" I.D.)
301A 35355Fuel Cap (Red Plastic)(1.75" I.D.)
338A 31291Plug, Cover
238 28820Screw, 10-32 x 1/2"
239 27272A* Gasket, Air cleaner
241 33266Bracket, Air cleaner
242 33267Bracket, Air cleaner
245 33268Element, Air cleaner
250B 33269ACover, Air cleaner
251 650513Nut, Wing 1/4-20
290 29774Fuel Line (Braided 8-1/4")(21cm)(As r equired)
290 30962Fuel Line (Braided 32")(80cm)(As requ ired)
291 30705Fuel Line (Braided 16")(40cm)(As requ ired)
293 33715Impulse Fuel Pump NOTE: 34385 and 33715 (WIP)pumps
are replaced by 35813 and 35800 (WIP) pumps. The 33010
(3000 series) repair kit is still available. The 35791 repair kit
is used with the 35813 and 35800 fuel pumps.
294 33010Fuel Pump Repair Kit NOTE: 34385 and 33715 (WIP)pumps
are replaced by 35813 and 35800 (WIP) pumps. The 33010
(3000 series) repair kit is still available. The 35791 repair kit
is used with the 35813 and 35800 fuel pumps.
294 35791Fuel Pump Repair Kit NOTE: 34385 and 33715 (WIP)pumps
are replaced by 35813 and 35800 (WIP) pumps. The 33010
(3000 series) repair kit is still available. The 35791 repair kit
is used with the 35813 and 35800 fuel pumps.
301A 410144BFuel Cap (White Plastic)(Standard) (Use as required) (1.5"
I.D.)
301A 33032Fuel Cap (Red Plastic) (Spurt Resistant, Low Profile) (Use as
required) (1.5" I.D.)
301A 34210Fuel Cap (Red Plastic) (Spurt Resistant, High Profile) (Use
as required) (1.5" I.D.)
301A 35355Fuel Cap (Red Plastic)(1.75" I.D.)
303 32958Fitting, Fuel
303 33713Fitting, Fuel line elbow
276 35741Plate, Muffler locking
277 650729Screw, 5/16-18 x 3-3/16" (Use as requ ired)
277 651002Screw, 5/16-18 x 4-1/4" (Use as requi red)
301A 410144BFuel Cap (White Plastic)(Standard) (Use as required) (1.5"
I.D.)
301A 33032Fuel Cap (Red Plastic) (Spurt Resistant, Low Profile) (Use as
required) (1.5" I.D.)
301A 34210Fuel Cap (Red Plastic) (Spurt Resistant, High Profile) (Use
as required) (1.5" I.D.)
301A 35355Fuel Cap (Red Plastic)(1.75" I.D.)
313A 33876Gasket, Stator (Used only on Std. poi nt ign.)
338A 31291Plug, Cover
361 30063Screw, Torx T-30, 1/4-20 x 1/2"
377 30547ABreaker Points (Use with Std. point i gn.)
380 632255Carburetor (Incl. 184 & 379) (Refer to Division 5, Section A,