For Discount Tecumseh Engine Parts Call 606-678-9623 or 606-561-4983
HH70-140036CPage 4 of 8
Engine Parts List #1
Ref # Part NumberQty Description
114 34186AFuel Tank (Incl. 115 & 266) NOTE: These tanks were built
with different size fuel inlet openings. Tanks with the 1-3/16"
I.D. opening use fuel cap 33032 or 34210. Tanks with the
1-1/2" I.D. opening use fuel cap 35355 or 35650.
115 410144BFuel Cap (White Plastic)(Std)(As requ ired)
115 33032Fuel Cap (Charcoal Plastic) (Spurt resistant, Low profile)
(Use as required)
115 34210Fuel Cap (Red Plastic) (Spurt resistant, High profile) (Use as
required)
115 35355Fuel Cap (Use as required)
116D 34159Plate, Fuel tank mounting
117A 32961Valve, Shut-off
118 29774Fuel Line (Braided 8-1/4" 21 cm)(Use as req.)
118 30705Fuel Line (Braided 16") (41 cm) (Use as req.)
118 30962Fuel Line (Braided 32") (81 cm) (Use as req.)
120 650128Screw, 10-24 x 1/2" (Use as required)
121 30622AExtension, Blower housing
124 650542Screw, 5/16-18 x 3/4"
127 26073Washer (Use as required)
128 650694AScrew, 5/16-18 x 2" (Use as required)
129 32589Key, Flywheel
130 31843ABracket, Governor gear
131 650836Screw, 10-24 x 1/2"
133 650599Screw, 1/4-20 x 1-1/2"
149 30747Clip, Shorting
151 650665Screw, 1/4-15 x 7/8"
193 610118Cover, Spark plug (Use as required)
205 650561Screw, 1/4-20 x 5/8" (Use as required )
209 30939ACover, Cylinder head
266 26460Clamp, Fuel line
270 31461Bushing, Crankshaft (Use as required)
271 33876Gasket, Stator
274 610973Terminal Ass'y. (As req. on late prod uction)
287 27275Clip, Hi-tension wire (Use as require d)
287 34246Clip, Ground wire (Use as required)
313 650625Washer, Thrust
331B 31752Decal, Air cleaner
331 550223Decal, Name
331A 34346Decal, Instruction
332 32434Contact Assy., Breaker
333 610767ACondenser
334 631021Inlet Needle, Seat & Clip Assy.
336 631453Carburetor (Incl. 75) (Refer to Division 5, Section A, page 100
for breakdown)
337 610816Magneto (w/ring gear) (12 Volt) (7 Am p) NOTE: The
complete magneto is not available as an assembly. The
magneto number is shown for reference purposes only.
Order component parts individually, as show in parts list.
(Refer to Division 5, Section B, page 26 for breakdown)
343 33239AGasket Set (Incl. items marked*)
www.mymowerparts.com
Page 5
For Discount Tecumseh Engine Parts Call 606-678-9623 or 606-561-4983
HH70-140036CPage 5 of 8
Engine Parts List #2
www.mymowerparts.com
Page 6
For Discount Tecumseh Engine Parts Call 606-678-9623 or 606-561-4983
HH70-140036CPage 6 of 8
Engine Parts List #2
Ref # Part NumberQty Description
31 650516Screw, 1/4-20 x 1-1/8"
34 27793Clip, Conduit (Use as required)
35 28942Screw, 10-32 x 3/8" (Use as required)
263 650764Nut, "U" Type (Use as required)
274 610973Terminal Ass'y. (As req. on late prod uction)
331 550223Decal, Name
339 35765AElectric Starter Motor (12 Volt) NOTE: The 29965, 32468,
32468B, 33606, 35765 and 35765A startermotors are used
interchangeably on these models. Refer to service number
stamped on end cap of motor, or on decal, for identification.
Refer to Division 5, Section D for breakdown.
340 33328DStarter Motor Kit (110-120 Volt) This 110-120 volt starter
motor kit may have been added to this engine. It can be
added only if cylinder hasdrilled and tapped starter mounting
bosses and a ring gear flywheel (see#342). Refer to service
number stamped on end cap of motor, or on decal, for
identifica
342 30811AFlywheel (Ring gear flywheel requiredon engines using
110-120 volt starter kits listed above)
342 611042Flywheel (Used on Type letters H and above) (Std. Point
ignition) (Ring gear flywheel required on engines using
110-120 volt starter kits listed above)
342 611085Flywheel (Minimum ring gear flywheel required on engines
using 110-120 volt starter kits listed above) (Use withSolid
State ignition)
www.mymowerparts.com
Page 7
For Discount Tecumseh Engine Parts Call 606-678-9623 or 606-561-4983
HH70-140036CPage 7 of 8
Engine Parts List #3
www.mymowerparts.com
Page 8
For Discount Tecumseh Engine Parts Call 606-678-9623 or 606-561-4983
HH70-140036CPage 8 of 8
Engine Parts List #3
Ref # Part NumberQty Description
27 27513Lockwasher, 1/4" (Use as required)
36 650697AScrew, 5/16-18 x 2-1/2" (Use as requi red)
36 650695AScrew, 5/16-18 x 2-1/4" (Use as requi red)
36 650694AScrew, 5/16-18 x 2" (Use as required)
38 27896A* Gasket, Breather cover
42 26073Washer (Use as required)
42 650691Washer, Flat (Use as required)
50 650548Screw, 8-32 x 5/16"
51 30319Rivet, Split (Used in early productio n)
52 32326ALever, Governor (New lever does not need 1 of
51,66,132,164,165,207)
55 30205Bracket, Adjusting
57 730130Exh.Adap.Kit (Incl. 58 & 125) (Use as req.)