TECshow reefTEC User Manual

USER MANUAL

Read the user manual before turning on the product.

1

INTRODUCTION

Thank you for using our Products .This lighting has got the nice sculpt , efficient , save
electricity and durable . It is suitable for disco, stage , building etc . Direct input of DMX512
signal to unit to allow it be controlled by any DMX512 controller. Powerful internal
programs allow customers to program freely to any different lighting project requirements
for installation or shows.

This product complies with the following standards:
IEC60598-1:2003
IEC60598-2-17:1984+A2:1990

DMX512 , Master/Slave , Sound active control mode
Professionally designed pre-programmed effects
Long-life LEDs
Strobe effect 1~20 flash per sec.
4 DMX-channels
9 Dip Switches for adjusting the DMX-starting address
DMX-control via every standard DMX-controller
Ø5 LED (16R+16G+16B+16W)X2
50 000 hours LED life
Compact housing

FEATURES

2

SAFETY INSTRUCTIONS

Important!

Please read these instructions carefully , which includes important information about the
installation, usage and maintenance of this product.

Every person involved with the installation, operation and maintenance of this device has
to be qualified and follow the instructions of this manual .
Manufacturer will not with responsibility for those operation not according to this
Instruction.

- Always make sure that you are connecting to the proper voltage, and that the line
voltage you are connecting to is not higher than that stated on the decal or rear panel of
the fixture.

- Always ground (earth) the fixture electrically.

- Do not attempt to bypass the fuse, and replace the defective fuse with ones of the

specified type and rating only.

- Do not spill water or other liquids into or on to your unit.

- During long periods of non-use, disconnect the unit's main power.

- Do not attempt to operate this unit if the power cord has been frayed or broken.

- Never use the device during thunderstorms. Over voltage could destroy the device.

Always disconnect the device during thunderstorms.

- There are no user serviceable parts inside the unit. Do not open the housing or attempt
any repairs yourself.

- Maximum ambient temperature (Ta) is 35°C.

- The surface temperature of the light can reach to 50°C .

- Do not attempt to operate this unit, if it becomes damaged.

- Always be sure to mount this unit in an area that will allow proper ventilation.

- Do not directly stare at the light when it works.

- When suspending the fixture above ground level, verify that the structure can hold at

least 10 times the weight of all installed devices.

- Verify that all external covers and rigging hardware are securely fastened and use an
approved means of secondary attachment such as a safety cable.

- Verify that all screws are tightly fastened.