Tecom Co WL503X User Manual

WL5030

WLAN Access Point

User’s Manual

Version 1.0

TECOM CO., LTD.

March 2003

©2003 by TECOM CO., LTD.

All rights reserved.

Printed in Taiwan

Table of Contents

Package Contents and Trademark(s)- ------------- 2
Software Installation ---------------------------------- 3
Utilities Using Guide -----------------------------------4
Configuration for Optional function----------------7
Point-to-Point Wireless Bridge-----------------------8
Point-to-Multipoint Wireless Bridge----------------9

Troubleshooting --------------------------------------11
Specifications ------------------------------------------ 13
Technical Support ------------------------------------ 13

1

Package Contents
The package you have received should contain the

following items:

 Wireless LAN Access Point
 CD ROM containing Utility Software and

User’s Manual

 Quick Installation Guide

Trademark(s)TM and Registered Trademark(s)®
TECOM and the TECOM logo are trademarks of
TECOM CO., LTD.

Microsoft, Windows are registered trademarks of
Microsoft Corporation. Other brand and product names
may be registered trademarks or trademarks of their
respective holders.

2

Software Installation Guide

For AP Configuration

1. Run the “Setup.exe” in the folder of AP Configuration of the
driver disk. Follow the guideline on the screen, and select
the directory where the application will be installed, it will
deploy all files that needed at that. At the end, windows will
show a message that installation is completed.

2. Power on the Access point.

3. Plug the “cross over” type Ethernet cord into both port of
host PC and AP. (If you don’t have “cross over” type
Ethernet cord and have a hub, then you can use normal type
Ethernet cable to connect both host PC and AP to hub.)

4. You can run the program of “AP Configuration”, which you
can find in “start” ”program” ”TECOM”
”SNMPManager”

5. Make sure that the IP address of your host PC and AP are in
the same sub-net, because this program is based on SNMP.
The default setting of IP address of AP is 10.170.254.37

3

Utilities Using Guide

For AP Configuration

When you run the AP Configuration, you will see a dialog box pop
up like below. Of course, the AP is already connected to your host
PC by Ethernet port.

1. Press “File””Find Access Point”, it will show a dialog box
like below to show you how many Access Points it found on
the net.

4