Tecom Co BT3061 User Manual

Bluetooth Headset User Manual

1. Getting Started

Charge the headset using the adapter. It takes 2 to 2.5 hours to fully recharge the
battery

2. Pairing

Press and hold the ON/OFF button until you hear two short low tones.
The headset indicator light flashes green and red, indicating the pairing mode is
on.
The default ID Code is “1111”.

3. Turn the headset on

Press and hold the ON/OFF button until you hear a short tone.
The headset indicator light flashes green, indicating the pairing mode is on. If the
battery is low, the light flashes red.

4. Turn the headset off
Press and hold the button key until you hear a short low tone following a short

high tone.

The headset indicator light is switched off.

5. Adjusting the volume

To increase the volume, press the “+” button
To decrease the volume, press the “-“ button

6. Making a call

Enter the number on the mobile keypad.
When the call has been set up, the voice will be transferred to headset.
End the call by pressing the ON/OFF button.

7. Answering calls

When the headset rings, press the ON/OFF button.
End the call by pressing the ON/OFF button.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT
TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

Notice: The changes or modifications not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.