Tecom Co AW4042UG User Manual
1. Install AW4042U
Back Panel
Quick Installation Guide
AW4042U
4-Ethernet Port ADSL/ADSL2+ WiFi CPE
Fig. 1.1 the Back Panel of AW4042U
Label Function
DSL RJ-45 connector: WAN interface to connect DSL line
USB
TV
LAN 1- 3 RJ-45 connector: Connect to the PC Ethernet port.
RST Reset button: Reset AW4042U to factory default setting.
DC-IN Connect to the supplied power converter cable
USB 2.0 connector: for printer and ext. Memory support
RJ-45 connector: Connect to the PC Ethernet port, or to STB
Table 1.1 Illustration of AW4042U Back Panel
- 1 -
Front Panel
There are 8 LEDs on the front panel which indicate the status of AW4042U showing as below:
Fig. 1.2 the Front Panel of AW4042U
Label Color Signalling Function
Flashing System start-up
POWER
Green
Red Lighted Factory reset / FW updating
Lighted Active connection
Off Power-off / General MODEM error
INFO
DSL
Green
Red Lighted No DSL correct user data
Green
Red
Green
Green
Lighted Active data session
Flashing Data transmission INTERNET
Flashing PPPoE authentication ongoi
Lighted PIN OK and active PPPoE Session
Flashing Data transmission
Lighted Waiting Pin insertion
Flashing PIN OK, waiting authentication
Lighted Wireless on
Flashing Data transmission WLAN
Off Wireless off
Slow
Flashing
Fast
Flashing
Lighted DSL synchronized
Off internal DSL error
sending pilot tones
DSL training
WLAN
On/off
Flashing Data transmission
Green
WLAN on/off : long press
WPS: short press
Table 1.2 Illustration of AW4042U Back Panel
Lighted active connection LAN1- 3/TV
Off no active connection
- 2 -
Connecting the Hardware
Before you begin, turn the power off for all devices.
These include your computer(s), your LAN hub/switch (if
WARNING
The layout of the ports on your device may vary from the layout shown. Refer to the steps that follow for
specific instructions.
applicable), and the AW4042U.
Figure 1.3. Overview of Hardware Connections
2. Login to AW4042U through web browser
I. Configure your PC IP address as 192.168.1.x within the same subnet as AW4042U (AW4042U default IP is 192.168.1.1)
and subnet mask (default is 255.255.255.0).
II. Connect AW4042U with PC through an Ethernet cable.
a. Turn on the power of AW4042U to establish ADSL link.
b. Enter the IP address (default is 192.168.1.1) of AW4042U from Web Browser. Login Dialog Box will pop up
as following:
- 3 -
c. Enter the management Username/Password and click the OK button (The default Username/Password is
admin/admin).
d. The first page will show the first page of Quick Setup. Follow the instructions to configure the AW4042U.
3. Quick Setup
I. Set up ATM PVC and QoS
Fig. 2.1 Login Dialog Box
II. Configure WAN Interface
- 4 -
Loading...