TECO seachill tr5, seachill tr10, seachill tr20, seachill tr30, seachill tr15 Operator's Manual

...
P
age 1
manual for all models:
TR5 TR10 TR15
TR20 TR30
TR60
P
age
2
P
age 3
Purchased From
Date Purchased
Date Installed
Table of Contents
Safety ........................................................................... 4
Notes:
About This Manual
This manual covers basic operation and maintenance for all current models of the Teco SeaChill under normal operating conditions. For more detailed information or uses not covered in this manual please contact us.
Contact Us
United Kingdom distributor:
TradeMark Aquatics Ltd
Tel: 01509 26233 0
info@trademarkaquatics.co.uk www.trademarkaquatics.co.uk
Model Number
Serial Number
Specifications
. . .. . . . .. . . . . . . . . . . . . .. . . . . . .
5
F
eatures . . .. . . . .. . . . . . . . . . . . . .. . . . . . .
6-7 Rec
eiving and Inspection
. . .. . . . .. . . . . . . . . . . . . .. . . . . . .
8
Parts
List . . .. . . . .. . . . . . . . . . . . . .. . . . . . .
9-10
Installation and As
sembly
. . .. . . . .. . . . . . . . . . . . . .. . . . . . .
11-14
Oper
ation and Settings
. . .. . . . .. . . . . . . . . . . . . .. . . . . . .
15-17
Maint
enance
. . .. . . . .. . . . . . . . . . . . . .. . . . . . .
18-22
Troubleshooting
. . .. . . . .. . . . . . . . . . . . . .. . . . . . .
23
P
age 4 P
age 5
Flow Rate
T
ank Siz
e
Dimensions
C
onnections
300
litres
180 - 600 gph
90 - 200 g 130 - 400 g
17" x 10 5/8" x 17 3/4"
5/8" or 3/4" Quick Disc
onnect
Teco chille rs are
desig ned and built with safety as a prim e consid er
ation ; indu stry-accepted
safety f
actors have been used in the desig n. Each chille r
is
inspec ted at
the f
act
ory f
or safety and operation. Any necessary adjustments are made before shipment. Follow the main tenance
sched ules outli ned in this manua l for
optim um perfo rmance
and safe
operation. Any repairs should be done only by qualified perso
nnel with proper training and
t
ools.
Car
efull y r
ead
all
safety r
equir ements before inst allation , opera tion or main tenanc
e. The requirements are essential to ensure safe operation. Failure to follow these guidelines v
oids the warranty and may r
esult in chill er damage or
persona l injur y.
Do
not install or try to r
epair a chiller that has been damaged in shipment.
See Receiving
And
Inspection for instructions.
• Turn off and unplug the chiller before pr
eforming any work. Electricity
has the pot
ential to
cause personal injury or equipment damage.
Do
not operate
the chiller at temperatures above
the maximum ambient temperature (95˚F
/35˚C)
Always supply electrical power that complies with the v
oltage
shown on the data label.
below the electrical outlet - this prevents water from reaching the outlet in the ev
ent of a leak.
• It is
rec
ommended that this pr
oduct be used with an
RCD (residual current device)
outlet.
Do
not look directly at an illuminated UV
light. (if installed)
Do
not operate
chiller without water flo
wing thr
ough it.
• Never
allow
heater to be on without water flo
wing though the chiller.
Do
not run pressurized
water thr
ough chiller. Chillers are designed to accept water flow from
recir
culating pumps. Pressure
pumps or high-pressure
water lines
will
damage
the chiller. If
in
doubt about your pump, c
ontact the pump manufacturer.
Safety
Specifications
Watts
200 230
420
Work on the refrigeration system must be done only by a licensed refrigeration technician.
Volts/Hz
110/60
Do not plug into wall socket without the housing in place.
dB / dB
(silent Mode)
39 / 37 40 / 38
41/ 39
Configure the electrical cord to include a “drip loop” - a loop section of chord that hangs
Weight
15 kg 39.5
lb.
44 lb.
HP
Amps
1/2 1
7.2
8.6
W
atts
818
980
110/60
111 lb.
V
olts/Hz
110/60 W
eight
96 lb. Flow
Rate
270 -
810 gph T
ank Size
up to
750 gallons
up to
1300 g
allons Dimensions
24" x
15" x 22"
C
onnections
1"
TR60 TR30
HP
1/8
1/5 1/3
Amps 2.5 2.6 3.9
TR20 TR15 TR10
HP
1/12
Amps
1.9
W
atts 180
V
olts/Hz 110/60
W
eight
14 kg
Flow Rate
500 l/hr
T
ank Size up to 150 litres
Dimensions
12.5" x 9
.5" x 13.5"
C
onnections
16mm or 20ml
Quick Disc
onnect
TR5
P
age 6 P
age
7
H
B
Features
J
A
Ventilation Grate
B
Air Filter
C
Control Panel
J
D
In Port
F
E
Out Port
L
F
Power Socket
D E
G
UV Port(s)
(Optional Accessory)
H
Heater Port(s) (Optional Accessory)
C
I
UV Ballast(s)
J
Compressor
A
H
G
K
Heat Exchanger
L
Condenser
M
Vent
Fan(s)
J
M K
TR10 TR15
D E
TR20
M
L
A
K
TR30
A
F
C
B E D
I
I
H/G
TR30
TR60
TR60
M
L
J
K
TR5
TR5
TR10
TR15
TR20
P
age 8 P
age 9
W
asher
TR10 TR15 TR20
TR5
TR30 TR60
Receiving and Inspection
Included Parts List
1
Inspe ct the chiller clo sely upon rec eipt.
Record any indicatio n of damage and contact seller immediately.
2
Save the box and packing mater ials
If your chiller ever needs to be repaired or servic ed, you will need to ship it in the original box.
3
Record your Model and Serial Number for easy referen ce
There is a space on the first page of this manual to record this informat ion. You may be asked for the serial number when calling for support .
In / Out Plugs
Located in the in/out ports of the chiller (2) Attached to chiller
Shutoff Valve
(2)
Elbow
chiller (2) Attached to chiller
Ring Nut
Attached to chiller (2)
WARNING:
When the chillers are inverted during maintenance or shipping, you must let the unit sit for at least 30 minutes upright to allow the coolant to settle: failure to do this before
O Ring
Attached to chiller (2)
Ring Nut
turning on the chiller may result in damage to the compressor.
Serial and Model Number Location
Housing Ring Nut
Attached to chiller (2)
Housing Gasket
Attached to chiller (2)
Located in the in/out ports of the chiller (2) Attached to chiller
Located in the in/out ports of the chiller (2) Attached to chiller
Power Cord
TR30/60 - Power Cord is attached to chiller
Fuse
1 installed, 1 spare
Air Filters
1 installed, washable / reusable
Bottom
Front , Underneath the Air Filter
Air filter must be removed to access the serial and model number
Back
Note: Color and appearance of actual parts may vary slightly
TR30 TR60
TR5 TR10 TR15 TR20
NO
TE:
Our Quality Control
proc
edure
includes running water thr
ough the chiller to test the
c
ooling capacity. There
may be r
esidual water in the unit due to this method of testing,
this
is
normal.
Loading...
+ 9 hidden pages