tecnotelai A971, A970, A972, A965, A966 Installation, Use And Maintenance Instructions

A90

Via Bonazzi, 4 - 40013 Castel Maggiore (BO)

Tel. [phone] (10 linee) - Fax [phone]

[e-mail] - www.tecnotelai.it

! /!1 4

!

TOOL HOLDER AND SALES COUNTERS

installation, use and maintenance instructions

* BEFORE USING THE CABINET check the floors, which must be in good condition and must have an
appropriate consistency for the capacity of the cabinet. In the case of floors with slight unevenness, shim the
cabinet and check the proper operation of the lock.

* FLOOR OR WALL MOUNTING is necessary in order to maintain the capacity of the drawers unchanged.

* DURING TRANSIT WITH PALLET TRUCKS he drawers must be closed and the front part must be facing
the operator and the forks inserted completely under the cabinet.

* MAKE SURE THE KEY IS IN OPENING POSITION BEFORE CLOSING THE DRAWERS.

* THE OPENING AND CLOSING OF DRAWERS must be done with only one drawer at a time.

A90

Via Bonazzi, 4 - 40013 Castel Maggiore (BO)

Tel. [phone] (10 linee) - Fax [phone]

[e-mail] - www.tecnotelai.it

! /!2 4

!

EXTRACTION OF DRAWERS.

Completely pull out the drawer
and slightly raise the front part.

"
"
"

SEPARATORS.

After inserting them it is
necessary to use the screws
supplied (2 for the slotted
ones and 1 for the smooth ones)
to stiffen the bottom.

INSERTION/REPLACEMENT OF DRAWERS LABELS.

With a screwdriver push the plastic closing cap towards the
outside to replace the labels.
Using pressure, fit the cap (right and left)

"
"
"
"

MOVING THE DRAWERS.

Remove the locking hooks "A" to free the guides "B";
reposition and lock them again with the hooks.

Slotted

longitudinal

separator

Smooth

transverse

separator

insertion

replacement

FITTING THE ADJUSTABLE SHELF.

Insert, at the same height, 4 hooks (G),
two front and 2 rear,
in the appropriate slots.
Place above the shelf (H).

ANCHORING THE CABINET TO THE FLOOR.

After positioning the cabinet, mount it to the floor with
2 anchors of external ø 8x75 (screw M8).

"
"
"
"

WALL MOUNTING.

After positioning the cabinet, remove the drawers.
Drill 2 holes in correspondence with the existing ones
in the top of the back of the cabinet and attach with
appropriate anchors and washers.

1

234

5

6

7