TECNO MOBILE KB8 Quick Start Guide

Explosion
Explosion
1 TP+LCM 2 UPHOUSING 3 MAIN PCBA 4 CARD HOLDER 5 REAR CAMERA 6 FRONT CAMERA 7 BAT&TP_BTB STEEL 8 REAR CAM DECO 9 UP FRAME 10 SCREW 11 LOWHOUSING 12 BATTERYCOVER 13 REAR CAM LENS 14 SCREW 15 SPK FRAME 16 FP 17 BATTERY 18 USB RUBBER 19 SIDEKEY FPC 20 MAIN FPC 21 SUB PCBA 22 CABLE LINE 23 SPK FPC 24 EASY PULL AD 25 AUDIO RUBBER
diagram
diagram
specification
specification
Know your phone
1. Front camera
2. Volume key
3. Power key
1
SIM/SD card installation
Power
off
Refertoto
off
mobile.
mobile.
the
the
following
following
picture
picture
for
for
SIM//SDSD
SIM
1.1.Power
2.2.Refer
card
card
installation.
installation.
Charging the phone
You
can
charge
your
device
You
can
the
totothe
Please
1.1.Please
Use
2.2.Use
may
may
warranty.
warranty.
charge
computer
computer
remind
remind
only
TECNO
only
TECNO
damage
damage
your
usingaa
using
the
the
the
the
device
front
front
charger
charger
device.
device.
USB
USB
and
and
and
and
This
This
usingaa
using
cable
cable
backofof
back
cables.
cables.
will
will
chargerororbyby
charger
(comes
with
(comes
with
the
plug.
the
plug.
Other
Other
invalidate
invalidate
connectingitit
connecting
the
phone).
the
phone).
chargersoror
chargers
your
phone
your
phone
cables
cables
FCC Caution
Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to following two conditions:(1)This device may not cause harmful interference and (2) this device must accept any interference reveived, including
interference that may cause undersired operation.
Information to user.
Any chang es or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FC C Rules. These limits are designed to provide reasonable protect ion against harmful interference in a residential installation. This equi pment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be deter mined by turning the equipme nt off and on, the user i s encouraged to try to correct the i nterference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equi pment into an outlet on a circuit different from that to
which the recei ver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Ra te (SAR) information:
This mobile phone meets the government's requirements for exposure to radio w aves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.
FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is
1.6W/kg averaged over one gram of tissue. Device types:KB8(FCC ID:
2ADYY-KB8)has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the ear is 1.19W/kg and when properly worn on the body is device was tested for typical body-worn operations with the back of the handset kept 10mm from the body.
RF exposure requirem ents, use accessories that maintain a 10mm separation distance between the user's body and the back of the handset.
The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that does not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided.
To maintain compliance with FCC
0.33W/kg. This
Loading...