①
Know your phone
1. Front camera
2. Volume key
3. Power key
2
SIM/SD card installation
1. Power off mobile.
2. Refer to the following picture for SIM / SD card
installation.
3
Charging the phone
You can charge your device using a charger or by connecting
it to the computer using a USB cable (comes with the
phone).
1. Please remind the front and back of the plug.
2. Use only TECNO charger and cables. Other chargers or
cables may damage the device. This will invalidate your
phone warranty.
4
FCC Caution
Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must a ccept any interference received,
including interference that may cause undesired operation.
Information to user.
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Information to the user.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the i nstructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference wi ll not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This mobile phone meets the government's requirements for exposure to
radio waves. The guidelines are based on standards that were developed
by independent scientific organizations through periodic and thorough
evaluation of scientific studies. The standards include a substantial safety
margin designed to assure the safety of al l persons regardless of age or
health.
FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is
1.6 W/kg averaged over one gram of tissue. Device types: CC6 (FCC ID:
2ADYY-CC6) has al so been tested against this SAR limit. The highest SAR
value reported under this standard during product cer tification for use at
the ear is 1.21W/kg and when properly worn on the body is 0.47 W/kg.
This device was tested f or typical body-worn operations with the back of
the handset kept 10mm from the body. To maintain c ompliance with FCC
RF exposure requirements, use accessories that maintain a 10mm
separation distance between the user's body and the back of the handset.
The use of belt clips, holsters and similar accessories should not contain
metallic components in its assembly. The use of accessories that does not
satisfy these requirements may not comply with FCC RF exposure
requirements, and should be avoided.
Loading...