
99MyMypicture
My picture can be used to browse images and photos from
mobile or SD card storage; editing functions can be
performed. Images can be designated as wallpaper or
contact avatar. The sharing function allows images to be
shared with friends via Bluetooth and MMS, etc.
picture
12

Factory
1111Factory
“Factory data reset” resets all configurations to their
default state. Internal mobile storage is cleared of all data
including apps, photos, music, videos, mail, contacts, etc.
This procedure may take a long time. Please wait patiently
for mobile to restart and do not power off.
WARNING:
Factory data reset as a last resort. Once activated all user
data & configurations are deleted and cannot be restored.
data
data
reset
reset
14

FCC Caution.
Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is
subject to the condition that this device does not cause harmful
interference.
Information to user.
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
Information to the user.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a reside ntial installation. This
equipment generates uses and can radi ate radio frequency ene rgy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
15

-Consult the deale r or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This Mobile phone meets the government's requirements for
exposure to radio w aves. The guidelines are based on standards that
were developed by independent sci entific organizations through
periodic and thorough evaluation of scientifi c studies. The standards
include a substantial safety m argin designed to assure the safety of
all persons regardless of age or health.
FCC RF Exposure Information and Statem ent The SAR limit of USA
(FCC) is 1.6 W/kg averaged over one gram of tissue. Device types:
AX8(FCC ID: 2ADYY-AX8) has also been tested against this SAR limit.
The highest SAR value reported under this standard during product
certification for use at the ear is 0.67 W/kg and when properly worn
on the body is 1.40 W/ kg. This device was tested for typical
body-worn operations with the back of the handset kept 10mm
from the body. To maintain compliance with FCC RF exposure
requirements, use accessories that mai ntain a 10mm separation
distance between the us er's body and the back of the handset. The
use of belt clips, holsters and similar accessories should not contain
metallic components i n its assembly. The use of accessories that do
not satisfy these requirements may not comply with FCC RF
exposure requirements, and should be avoided.
Body-worn Operation
This device was tested for typical body-worn operations. To comply
with RF exposure requi rements, a minimum separation distance of
1.0 cm must be m aintained between the user’s body and the
handset, including the antenna. Third-party belt-clips, holsters, and
similar accessories used by this device should not contain any
metallic components. Body-worn accessories that do not meet these
16

requirements may not comply with RF exposure requirements and
should be avoided. Use only the suppli ed or an approved antenna.
17