Tecnolec TC145W-U, TC145SL-U, TC145BK-U, TC100W-U Instruction Manual
FP)ULGJH-)UHH]HU
7&:8
INSTRUCTION MANUAL
MODEL: 7&6/8
7&%.8
Names of parts
1
Note: Compartment design may change due to product improvement,
No prior notice willbe given.
THANK YOU FOR PURCHASING THIS TECNOLEC PRODUCT
This booklet contains the information you will require to install and operate your new
appliance.
It is important and worthwhile spending time to fully read this booklet so you will
understand how to operate the appliance safely and efficiently.
Please keep this booklet in a safe place so that you can refer to it when required.
ELECTRICAL CONNECTION (UK ONLY)
For your safety please read the following information.
Warning: This appliance must be earthed.
The appliance must be connected to a 240 volts 50 cycle AC supply by means of a three
pin socket, suitably earthed and should be protected by a 13 amp fuse in the plug.
The appliance is supplied with a standard 13 amp 3-pin plug fitted with a 13-amp fuse.
Should the fuse require replacement, it must be replaced with a fuse rated at 13 amp and
approved to BS1362.
If the mains plug is unsuitable for the socket outlet in your home or is removed for any
other reason, then the cut off plug should be disposed of safely, do not insert the cut off
plug into a mains outlet to prevent the hazard of electric shock. Remove the fuse before
disposal.
There is a danger of electric shock if the cut off plug is inserted into any 13-amp socket
outlet.
How to wire a 13 amp plug:
Important
The wires in the mains lead on this appliance are colored in accordance with the following
code:
Green and Yellow - Earth
Blue – Neutral
Brown – Live
As the colours may not correspond with the markings identifying the terminals in your plug
proceed as follows.
The green and yellow wire must be connected to the terminal in the plug which is marked
with the letter E or with the earth symbol or colored green and yellow.
The blue wire must be connected to the terminal marked N.
The brown wire must be connected to the terminal marked L.
You must make sure the mains cord is firmly secured under the cord clamp.
2
3
REFRIGERATOR SAFETY INFORMATION
Check that the voltage marked on the rating plate matches that of your local supply.
Failure to use the correct voltage will render the guarantee VOID and may cause damage to
the appliance.
The manufacturer accepts NO responsibility for using any other voltage than that marked on
the rating plate.
This appliance is intended for domestic use only; any other use may invalidate the warranty
and might be dangerous.
This appliance is intended for indoor use only, do not use or store outdoors. This appliance
shall not be exposed to rain.
The mains plug shall be the main disconnect device and shall remain operable at all times.
A short power-supply cord is provided to reduce the risk of a tripping hazard.
To disconnect from the mains completely, turn the appliance OFF, then remove the plug from
wall outlet.
Do not immerse the appliance, its lead or plug in water or any other liquid.
Remove all food and unplug from the supply when not in use and before cleaning the
appliance.
If the mains lead becomes damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified person with a specially prepared lead of the same type and rating
to avoid a hazard.
Do not operate the appliance with a damaged cord or plug or after the appliance malfunctions
or has been damaged in any way.
Do not let cord hang over edge of the surface, or touch hot surfaces.
Do not place the appliance on or near hot surfaces, or in direct sunlight.
Children must be supervised to make sure they do not swing on the door.
Accessible surfaces may get hot when in use, use handles and knobs at all times.
Always attach a plug to the appliance, and then plug it into the wall outlet and switch on.
If you are discarding an old appliance with a lock or catch fitted to the door, ensure that it is
left in a disabled condition to avoid the entrapment of young children when playing.
As old refrigeration appliances may contain CFC’s which will damage the ozone layer, when
disposing of any refrigeration appliance please contact your local waste disposal department
for advice on the correct method of disposal.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play on or near the appliance.
4
This appliance is for refrigerating food only.
REFRIGERANT
The refrigerating gas contained in the circuit of this appliance is Isobutane (R600a); it causes
a low level of pollution but is inflammable.
CAUTION:
Extreme caution must be used when moving the appliance.
WARNINGS:
Do not damage the refrigerant circuit.
Do not use sharp or pointed objects such as knives to remove ice when defrosting.
Do not use mechanical devices or other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
Do not use electrical appliances inside the food storage compartments of the
appliance, unless they are of the type recommended by the manufacturer.
If the appliance is installed in a carpeted area, do not let the carpet block the
ventilation holes in the base of the unit, adjust the levelling feet after a few hours to
compensate for carpet movement.
Keep ventilation openings, in the appliance enclosure or the built in structure clear of
obstructions.
Installation
Position the appliance and allow to stand for two to three hours before it is turned on
for the first time to allow the system to settle. Do not position next to any heat source
e.g. cooker, boiler or in direct sunlight etc.
A clearance of 10 cm must be left between the sides of the appliance and any adjacent
cabinets or walls to allow for adequate air circulation. The appliance is not designed for
recessed installation (“building in”).
Install on a good firm level surface, and any unevenness of the floor should be
corrected prior to installation, slight unevenness can be overcome by adjusting the
front feet.
Do not keep your appliance in a room where the temperature is likely to fall below 16
degrees C (61 degrees F) at night and/or especially in winter, as it is designed to
operate in ambient temperatures between +16 and +32 degrees C (61 and 90 degrees
F). At lower temperatures the appliance may not operate, resulting in a reduction in
the storage life of the food.
Do not place the appliance near cookers or radiators or in direct sunlight, as this will cause
extra strain on the appliance’s functions.
If installed next to a source of heat such as a fridge, maintain the following minimum
clearances.
Choose a well-ventilated location with no less than 10cm clearance around the refrigerator.
Place the refrigerator in a location with a firm base in order to prevent vibration and excessive
noise.
Level the refrigerator by adjusting the two front feet.
Loading...