Tecknet M002 User Manual

RF 2.4GHz Cordless Optical Mouse (2000DPI)

Manual

SKU:M002

Caution: To use this device correctly, please read this manual
before use.

For German, French language user manual, please
download from our website: www.tecknet.co.uk .
Sorry for the inconvenience.

System Requirements

To use this mouse, your computer must meet the following hardware
requirements and run one of the operating systems listed below.

Hardware

• PC with a Pentium processor or equivalent AMD processors

• USB 2.0

Operation System

• Windows2000,2003,XP,Vista,Win7,Win8,Win8.1 .

Note: The scroll wheel only works under the operating systems listed
above. If you use the mouse under a different operating system, the
mouse may either not work or lose its enhanced features and function
as a standard five-button mouse only.

Supplied with the Product

• 1 × Cordless Mouse

• 1 × USB Nano Receiver

• 1 × User Manual

• 1 × Warranty Card

5-Button Mouse

The mouse is featured with five buttons and one scroll wheel as
shown in below picture.

1. Left Click Button

2. Right Click Button

3. Scroll Wheel

4. DPI Switch Button/Low Battery Indicator

5. Froward Button

6. Backward Button

4

3

2

1

5

6

Scroll Wheel

DPI Switch Button/

Low Battery Indicator

Right Click Button

Backward Button

Froward Button

Left Click Button

1

18-Month Battery Life

The mouse consumes little power and offers a long battery life of up

to 18 months without changing battery. However please note that the

actual battery life may vary based on user and computing conditions.

Start for using

1.Connecting the Receiver
Take out USB Nano receiver and plug it into a free USB port in your
computer. The Plug & Play function automatically.

USB Port Nano receiver

2

1

2

2. The RF 2.4GHZ optical mouse uses one AA battery (Battery is not
included). Open the battery cover. Insert the batteries into the

compartment, ensuring they correspond with the polarity marking.

3. Replace the battery cover.

4. Switch on the mouse by adjusting the power switch underneath the

mouse. The red LED of the power indicator at the top of the mouse
will flash. (DPI will flash about 5-10 seconds, which is pairing process)

5. Now the mouse is ready for using.
Note:

1. Pairing process will stop if loading the battery first and then plug the
Nano receiver beyond 5-10 seconds.

2. Make sure that the polarity of the batteries is correct. The positive (+)
and negative (-) ends of each battery must match the positive (+) and
negative (-) markings in the battery housing.