TECHVIEW QC-3402 User Manual

Digital 2.4GHz 3.5” LCD Monitor

QC-3402

User Manual

Specifications:

3.5” LCD Monitor

Power Consumption: 400mA
Frame Rate: 25fps
Run Time: 4 hours continuous
Input Voltage: 5VDC @ 1A
Dimensions: 84(W) x 126(H) x 20(D) mm

Monitor Setup Instructions:

Install the battery into the unit by sliding the battery cover off, inserting the supplied
rechargeable battery in the correct polarity, and replacing the battery cover.

Use Instructions:

Starting up and shutting down:

- Press and hold the ‘ON/OFF’ key (on the right side of the camera) for 3 seconds

to start up. The logo will be displayed with a single ‘beep’ sound.

- On the display: standby picture, transmission signal, battery icon, time and date.

- The screen will enter into standby mode after several seconds if no buttons are

pressed. In standby mode, the red LED will flash every 4 seconds.

- When the battery is low, the red LED will flash every second. Please recharge

the unit/battery when this occurs.

- To lock and unlock the monitor, press the ‘ON/OFF’ button once.

- Press and hold the ‘ON/OFF’ key for 3 seconds to shut down.

Pairing the Monitor and Camera (up to 3 monitors can be paired to 1 camera):

- When the monitor is off, press and hold the ‘ON/OFF’ button and when the logo

is displayed on the screen, immediately click the ‘ON/OFF’ button again 5 times,
the screen will show ‘Pairing’.

- At the same time, press the ‘Reset’ button of the outdoor camera twice. The

red LED will flash and then attempt to pair to the monitor.

- If an image from the camera shows up on the screen of the monitor, the pairing

has been successful. If no image shows up within 1 minute, attempt to pair it
again.

- One pairing has been completed for multiple units; test it by pressing the ‘Call’

button on the outdoor camera, if the monitors all display then they have all
been paired correctly.

Menu:

- When the screen is lit up (if the unit is in standby mode, press the ‘ON/OFF’ key

to activate the screen again), press and hold the ‘FUNC’ key to enter into the
menu. Press the ‘FUNC’ key in sequence to enter into ‘Time Setting’, ‘Ring
Setting’, ‘Lock Delay Setting’ and ‘PIR Setting’ respectively.