Techview LA-5336 User Manual

MONITOR

Dummy Camera Theft

Prevention Kit

www.q-see.com

User Manual

LA-5336

Box Contents:

2 x Dummy Bullet Cameras

2 x Dummy Dome Cameras

4 x CCTV Security Stickers

4 x Mounting Hardware

Product Diagram:

Distributed by:

TechBrands by Electus Distribution Pty. Ltd.

320 Victoria Rd, Rydalmere

NSW 2116 Australia

Ph: 1300 738 555

Fax: [phone]

www.techbrands.com

Specifications:

IR LEDs: 23 x IR LEDs (Bullet)

1 x Flashing LED (Dome)

IR Interval: Auto IRNightime Switching (Bullet)

5Seconds (Dome)
IP Rating: IP44 (Bullet)
Batteries: Requires 2 x AAA (Bullet)

Requires 3 x AA (Dome)
Battery Life: Up to 3 Months (Depending on Infrared use)
Dimensions: 170(L) x 58(Dia)mm (Bullet)

125(Dia) x 95(H)mm (Dome)

Installation:

Safety:

BulletCamera:

1.Slide the top cover off the camera and open the battery
compartment.

2. Insert 2 x AAA batteries into the battery compartment using the
correct polarity indicated by the positive (+) and negative (-) markers.

3. After the batteries have been inserted; close the battery cover and
slide the camera cover back on.

4. Rotate the camera housing by 180° so that the camera is in an
upright position.

5. Position the camera in the location you want such as a wall or
ceiling and mark the screw holes to match the camera.

6. Fix the camera in place by using the screws provided or wall plugs if
you're drilling into surfaces such as brick or concrete.

Dome Camera:

1.Open the battery compartment cover located on the top of the
camera.

2. Insert 3 x AA batteries into the battery compartment using the
correct polarity indicated by the positive (+) and negative (-) markers.

3. After the batteries have been inserted; close the battery cover.

4. Using the included mounting guide; mark the screw holes in
the wall or ceiling where you wish to mount the camera.

5. Fix the camera in place by using the screws provided or wall plugs if
you're drilling into surfaces such as brick or concrete.

6. Leave the screw and wall plugs out of the screw holes slightly so
that it can attach to the screw mounts on the camera.

7. Place the dome camera on the screw holes and twist clockwise
depending on the installation to hold the camera in position.

1. Only Install the domecameras indoors and the bullet camera

undercover to avoid exposure to rain and mosture.

2. Ensure only Alkaline batteries are used with the correctly polarity
otherwise it may damage the cameras.

3. Don't modify or open the housing of the camera.