Technotherm ISP-W 350, ISP-W 950, ISP-W 600, SP-W 750, ISP-W 1200 Installation And Technical Manual

Installation and technical manual

ISP-W / R / B / Motifs frameless – with receiver RF

GB

13

14

ISP-W 350 - 1200

ISP-R 350 - 1200
ISP-B 350 - 1200

ISP-Motif 350 – 1200

ISP-W 351 - 851
ISP-R 351 - 851
ISP-B 351 - 851

ISP-Motif 351 till 851

with receiver RF

Edition: 12/17
No. 911 360 671

2 Edition: 12/17

Manual ISP W / R / B / Motive- frameless

1. Important Safety instructions

• People (including children) who are limited in their physical,

sensory, or mental capacities should not use this device at any
time. Furthermore do not handle this instrument if you do not
possess the necessary experience and knowledge to do so. This
device should only be handled under the supervision of a qualified
person and after a thorough introduction.

• Do not leave children alone with the device, and supervise them at

all times to keep them from getting harmed.

• WARNING: Do not cover! Otherwise this instrument will

overheat.

• Do not place the heater underneath a socket, drainage or the like.

• To keep from getting burned, do not touch heater´s surface

whenever it is turned on.

• Please use the handle whenever you have to move the heater.

• Do not put the cord underneath the carpet or a rug and make sure

that it is not a tripping hazard

• Plug the heater into properly grounded sockets only.

• Do not use the heater in any other way than described in the user

manual. Any other way of use may lead to fire, electrocution, and
may cause serious harm to the person.

• Do not use this device near bathtubs, showers or swimming pools.

• In case the connection cable is damaged it has to be replaced by

the manufacturer or someone commissioned by the manufacturer.

WARNING: Do not use a switching-oriented device, like a timekeeper,
when operating this heater. This could cause a change in the thermal
adjustment which is potentially hazardous!

• To keep the device from overheating do not put towels or clothing

on top.

• When using the heater, make sure it is in an upright position and

positioned on an even and dry place.

GB

3 Edition: 12/17

Manual ISP W / R / B / Motive- frameless

• Do not put any foreign objects into the vent. This may cause

electrocution, fire or damage to the heater.

• Do not use an extension cord unless approved by an electrician.

• This device is for private use only, do not use in any other way than

intended by the manufacturer.

• Do not use the device near curtains, highly combustible, extremely

explosive or malleable materials.

• Keep a distance of a at least 1.0 m between combustible materials-

like furniture, cushions, bedding, paper, clothing, curtains-and the
heating device.

• Do not use the device in rooms were petrol, paint or any other

flammable liquids are stored.

• Do not use the device outside.

Warning! This device has to be grounded

This device may only be operated using alternating current and

the operating voltage indicated on the power rating plate

• Nominal Voltage 230V AC, 50 Hz

• Protection class I

ISP-W (white front panel, powder-coated)
ISP-R (red front panel, powder-coated)

ISP-B (black front plate, powder coated)
ISP-Motif (front plate with motifs)

Prior to commissioning, please inform yourself about proper installation, commissioning, operation and
maintenance.
Below we give the necessary information:
The installation and electrical connection must be carried out by a qualified electrician. The panels are
designed for wall and ceiling mounting.

Wall mounting model ISP W / R / B / Motif

The plate can be mounted horizontally or vertically. Drill mounting holes as indicated in Fig.1
(horizontally) or as in Fig.2 (vertically). The pack contains 4 (6 for the Models ISP 1200 and ISP 851) fixing
screws 6 x 70 mm.

To mounting the unit using all 4 (6 anchors for the Models ISP 1200 and ISP 851. The recommended
dowel size is 10 mm (not included).
The dimensions A and B are pitches of the holes to be drilled.

GB