Technoline WZ 1300 User Manual

WZ 1300 Moisture Meter manual

Please read the manual carefully and familiarize yourself with the functions of the unit before
using it. Retain these instructions for future reference and pass them on together with the
device when you pass on the device to other users.

Scope of delivery

Immediately after unpacking please check the package contents for completeness and if all
parts and the product are in good condition.
1 Moisture Meter
1 Instructions for use

Technical Data

Operating voltage: 9V , 15 mA
Battery type: 6F22/6LR61 (9 V block battery)

Operating temperature: 0 °C to 40 °C
Protection class: IP 20
Resolution: 0.1%
Air humidity: up to a maximum of 80% (relative)

Prodcut Overview

(1) Protective cap
(2) Measuring pins
(3) MODE button (Material selection)

(4) button (displays measurement on
screen,° C or °F pre-selected)

(5) button (ON/OFF)

(6) Battery compartment
(7) Display
(8) Moisture indicator in %
(9) Material number
(10) Battery indicator
(11) Lock symbol (Measured value frozen)
(12) Temperature display (°C or °F)

General safety information

This unit can be used by children aged 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they are supervised and
have been instructed concerning the safe use of the appliance and have understood the
resulting risks. Children should never play with the device. Cleaning and user maintenance
must not be performed by children without supervision.

Intended use

This device is suitable for measuring wood and building moisture, for example in firewood,
paper, cardboard, mortar, concrete or plaster. The device is only intended for use in private
households, and not intended for commercial use.

Attention!

The measuring pins are very sharp. Be careful while handling this unit.
Always keep the protective cap on the unit, while it is not in use, in order to avoid the risk of
getting hurt.

Before using

Before initial use, remove the protective film from the device display (7) and insert the
enclosed battery.