Techno Line WT 495 Instruction Manual

INSTRUCTION MANUAL
WT 495 LED CLOCK

INSTALLATION

Plug in the AC/DC adaptor to any AC household outlet. Then plug in the DC jack to the back of
your unit.

Peel off the protective label on the front of your LED clock, the clock will display 0:00 and it is ready
to work for you.

BACK-UP BATTERY

1. Slide open the battery cover at the back of your clock.

2. Insert 1 x CR2032 lithium battery into the battery compartment with the + ve polarity facing up.

3. Replace the battery cover.

When AC power is off, the batteries will back the clock to keep track of time and the alarm time.
The LED display is off when only the back-up battery is being used.

TO SET TIME AND ALARM TIME

1. To set time, press and hold TIME, then press HR to set the hours. Then press and hold TIME
and press MIN at the same time to set the minutes.

2. To set alarm time, press and hold ALARM, then press HR to set the hours. Then press and hold
ALARM and press MIN at the same time to set the minutes

TO TURN ON / OFF ALARM

Press Zz ●●● zZ and ALARM together once to turn on the daily alarm, the AL LED will appear on
upper left of time display.

Press Zz ●●● zZ and ALARM together once to turn off the daily alarm, the AL LED will disappear
on upper left of time display.

TO USE SNOOZE ALARM

When time reaches your set alarm time, your clock will give a beep sound to wake you up. The AL
LED will flash.

1) Press the Zz ●●● zZ once to stop the alarm temporarily, the AL LED keeps flashing. The alarm
will beep again in 9 minutes.

2) To stop the alarm, press and hold the Zz ●●● zZ or any other key until AL LED becomes static.
The alarm beep will stop will beep again at the same time next day.

Alarm Duration : 5 minutes

HI-LO DIMMER SENSOR

This clock is equipped with a light sensor which adjusts the brightness of the LED display and the
mood light to a comfort level when the room environment is dim.

TROUBLE SHOOTING

In case your clock shows irrelevant information or digits, it maybe affected by electrostatic
discharge or interferences from other devices, press the RESET button on the back of your unit.
Your unit will be reset to default setting of time and alarm time and you need to set it to the current
time and to your desired alarm time again.

CARE OF YOUR LED CLOCK

Do not expose the unit to extreme temperature, water or direct sunlight
Avoid contact with any corrosive materials
Do not subject the unit to excessive force, dust or humidity
Do not open the inner back case or tamper with any components of this unit
Do not plug in any other AC/DC adaptor with incorrect specifications or voltage