Technoline WT-181 Instruction Manual

Istruction manual WT-181

Main Unit Appearance

Part A-LCD

A1: Radio signal received icon. A4: Day of Week
A2: Radio controlled Time. A5: Alarm icon
A3: Month / Date. A6: Temperature

Part B-Button
B1: MODE BUTTON B2: “▲” BUTTON
B3: “▼” BUTTON B4: “C/F” BUTTON
B5: SNOOZE/LIGHT BUTTON
B6: “ALARM,SNOOZE ON/OFF” Slide key

Part C-Structure

C1: Battery Compartment

Set Up:

z Remove battery compartment door at the back of the unit.

z Insert one AA battery.
z Press "RESET" hole inside the battery door the unit with a pin.

Radio Controlled Time:

z The clock automatically starts scanning the DCF frequency signal after new

batteries inserted ( “ “ flashes on the LCD)

z The clock automatically scans the time signal at 3:00a.m. everyday

to maintain accurate timing. For failed reception in 4 minutes, scanning stops

( “ “ on LCD disappear) and repeats again at 4:00a.m., 5:00a.m., and

6:00a.m.

z The clock manually scans the time signal by hold ▲”(B2) & “▼”(B3) buttons. For

failed reception in 4 minutes, scanning stops (“ “ on LCD disappear) and
repeats again in the next hour. e.g. scanning at 8:20a.m. fail, it will scan again at

9:00a.m.

z Hold ▲”(B2) & “▼”(B3) button for 3 seconds to stop scanning.

* flashes indicate now is receiving DCF signal

Turns on indicate signal received successfully

“DST” shown on the LCD if it is in Daylight Saving Time Mode

Manual Time Setting:

z Press “MODE” (B1) button to select time display.
z Hold “MODE” (B1) button for 3 seconds and time flashes.
z Press “▲”(B2) & “▼”(B3) to adjust Time, Year, Month and Date.
z The setting sequence is shown as follow: Hour, Minutes, Second, Year, Month, Day ,

Language of Weekday,Time Zone.

z Press “MODE” (B1) button to confirm each setting.
z There are 7 languages, English, German, French, Spanish, Italian, Dutch and

Denmark, for day-of-week. The languages and their selected abbreviations for each
day of the week are shown in the following table.