Technoline WS 6710 User Manual

WS 6710 Instruction manual

Main Unit Appearance

Part A- LCD

A1: Moon Phase A3: Weather Forecast
A4: Time Display A5: Second,Week,Alarm mode Icon display
A6: Indoor Temperature. A7: Outdoor Temperature

Part B- Buttons

B1: “AL ON/OFF” button B2: “CHANNEL” button
B3: “MAX/MIN “ button B4: ”SNOOZE/LIGHT” button
B5: “MODE”,”SETTING” button B6: “+(12/24)” , “WEARTHER”button.
B7: “- (°C/°F)” button B8: “RESET” button

Part C- Structure

C1: Wall Mount Hole C2: Battery Compartment
C3: Stand

Thermo Sensor Unit Appearance.

D1: Transmission Indication LED D2: Outdoor Temperature

D3: Wall Mount Hole D4: °C/°F” button
D5: “TX” button D6: Battery Compartment
D7: Stand

Set Up:

y Insert batteries.
y Use a pin to press the RESET (B8) button

Weather Forecast Function:

z After Batteries inserted, or holding “WEATHER” button (B6) for 3 seconds, weather icon Flash (A3).

Enter the current weather pressing “- “ (B7) buttons. Press “ + “ (B6) button to confirm the setting.
The weather forecast may not be accurate if the current weather entered is not correct.

z The current weather status should be entered again if the altitude of the Main Unit is changed.

( Barometric pressure is lower at higher altitude location. Therefore, altitude change will affect the
weather forecast). The weather station will start the first forecast at 6 hours later after the current
weather status is entered.

z Totally 5 different weather status symbols in the weather forecast. They are forecasting the weather

in future.