Techno Line WIRELESS 868 MHz TEMPERATURE STATION Instruction Manual

WIRELESS 868 MHz TEMPERATURE STATION

nction

keys

INTRODUCTION:

Congratulations on purchasing this temperature station with wireless 868 MHz transmission of outdoor temperature and display of indoor temperature. With two easy to use function keys, this innovative product is ideal for use in the home or office

FEATURES: Temperature station

LCD display

Instruction Manual

Hanging hole

Battery compartment

Stand

The Temperature Station

• Manual time setting (hour and minute display)

• Time display 24-hour time format

• Temperature display in degree Celsius (°C)

• Indoor and outdoor temperature display with MIN/MAX records

• Low battery indicator

• Wireless transmission at 868 MHz

• Signal reception intervals at 8 seconds

• Wall mounting or table standing

The Outdoor Temperature Transmitter

SETTING UP: Note: this temperature station can only receive one transmitter only.

• Remote transmission of outdoor temperature to Temperature Station by 868 MHz signals

• Rain proof casing

• Wall mounting and table-standing

•

Mounting at a sheltered place. Avoid direct rain and sunshine

1. First, insert the batteries to the transmitter (see “How to install and replace batteries in the Temperature transmitter” below).

2. Within 30 seconds of powering up the transmitter, insert the batteries to the Temperature Station (see “How to install and replace batteries in the Temperature station” below). Once the batteries are in place, all segments of the LCD will light up briefly. Following the indoor temperature, the time as 0:00 will be displayed. If they are not shown in LCD after 60 seconds, remove the batteries and wait for at least 60 seconds before reinserting them. Once the indoor data is displayed user may proceed to the next step.

3. After the batteries are inserted, the Temperature Station will start receiving data signal from the transmitter. The outdoor temperature should then be displayed on the Temperature station. If this does not happen after 2 minutes, the batteries will need to be removed from both units and reset from step 1.

4. In order to ensure sufficient 868 MHz transmission however, this should under good conditions be a distance no more than 80 meters between the final position of the Temperature Station and the transmitter (see notes on “Positioning” and “868 MHz Reception”).

HOW TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE STATION

HOW TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE TRANSMITTER

The Temperature Station uses 2 x AA, IEC LR6, 1.5V batteries. When batteries will need to be replaced, the low battery icon will appear on the LCD. To install and replace the batteries, please follow the steps below:

1. Lift up the battery compartment cover.

2. Insert batteries observing the correct polarity (see marking).

3. Replace compartment cover.

The Temperature transmitter uses 2 x AAA, IEC LR3, 1.5V batteries. When batteries will need to be replaced, the low battery icon will appear on the LCD of the Temperature Station. To install and replace the batteries, please follow the steps below:

1. Remove the battery compartment cover.

2. Insert the batteries, observing the correct polarity (see marking).

3. Replace the battery holder to the unit.

Note:

ET key

In the event of changing batteries in any of the units, all units need to be reset by following the setup procedures. This is because a random security code is assigned by the transmitter at start-up and this code must be received and stored by the Temperature Station in the first few minutes of power supplying.

BATTERY CHANGE:

It is recommended to replace the batteries in all units regularly to ensure optimum accuracy of these units. (Battery life –see Specifications)

FUNCTION KEYS:

The Temperature Station has only two easy to use function keys:

Please participate in the preservation of the environment. Return used batteries to an authorized depot.

+ key

+ 10 hidden pages