Techno Line MA 10660 User guide

Quick reference

MA10660 wind

sensor

MOBILE-ALERTS Sensor

This is a sensor for the "MOBILE-ALERTS" system, it
can be used with this system only. To use the sensor
you need a MOBILE-ALERTS gateway.

Quick Setup

Remove the plastic foil from the solar panel (1) on the
sensor. The wind sensor must be installed with the front
of the sensor (the solar panel) facing true South, or the
reported wind direction will not be accurate. Secure the
main unit to the shaft of the mast holder (2). Use the
right-angle adaptor (3) if the wind sensor will be
mounted on a horizontal mast or surface. Fasten the
mast holder to a suitable mast using the two U-bolts,
washers and nuts included. Mount the wind sensor onto
a mast so the wind can reach the sensor unobstructed
from all directions for an accurate reading. The ideal
mast is between 15.75 mm and 33 mm in diameter.
The wind sensor DOES NOT have replaceable
batteries, it consumes solar power and charges the
internal battery pack automatically

Add Sensor

Open the app, dashboard is displayed. Tap "Add new
sensor" and scan the QR code on the base of the wind
sensor. Then set a name for the sensor.

Specifications

Power: Solar panel,

Measuring range: 0 – 50 m/s
Accuracy: 5% +/- 0.5 m/s
Wind directions: 16 directions, 22,5 °

Transmission range: 100m (open area)

More information and detailed instructions can be found
in the app at “Info” or at www.mobile-alerts.eu

The declaration of Conformity can be found at:

www.mobile-alerts.eu/technoline/doc

charges
2 x integrated
Micro
(LR03, AAA)
rechargeable
alkaline batteries

resolution

Old batteries do not belong into general household
waste. You are obliged to return used batteries to your
vendor or collection points.

Electrical devices have to be disposed separately from
the general household waste. Take your old electronics
to your local waste collection point or recycling centre.