Untitled-3 7/17/01, 5:21 PM1
RR200PLM
RR200PLM
RR200PLL
Pykoßoactbo no okcnnyataunhn
Instrukcja obstugi
Hasznaiati Útmutató
Bruksanvisning
installationsvejledning
Brukerhandbok
Kayttoohje
Manual de utilización
Gebruiksaanwijzing
Manual de instalação
Manuale di utilizzazione
User manual
Manuel d'utilisation
Bedienungsanleitung
550 207 30
550 207 30
550 207 10
550 207 30
RR200PLM
RR200PLL
FRANCE
RCS Nanterre
B 322 019 464
THOMSON
multimedia
46/47
quai A. Le Gallo
92648 Boulogne
CEDEX
MAINS CONNECTIONS (FOR UNITED KINGDOM ONLY)
CAUTION:CAUTION:
CAUTION:
CAUTION:CAUTION:
Do NOT under any circumstances plug the
severed plug into any mains socket as this
could result in electric shock.
Do NOT make any connection to the terminal
in the plug which is marked by the letter E or
by the earth symbol or coloured green
and yellow.
A fuse plug must be fitted with a 3A fuse
approved by ASTA or BSI to BS 1362 and fuse
covers must always be securely replaced. If
your RR-200PLL/RR-200PLM does not work,
the fuse may be blown.
USEFUL ADVICE
. Do not use your set immediately after transport from a cold
place to a warm place: there may be condensation problems.
. This set uses a laser beam. To prevent any accident due to this
type of beam, the set should only be opened by properly trained personnel.
. Make sure that you keep your set away from water and high
temperatures.
. If you do not use your set on battery power for more than one
month, we advise you to take out all the batteries.
. To prevent personal injury, do not reverse any battery and do
not mix battery types.
ECOLOGY
. Help protect the environment - we recommend that you dispose
of used batteries by putting them into specially designed
receptacles.
MAINTENANCE
. Clean the unit with a soft cloth, or a damp chamois leather.
Never use solvents.
Connect the
power cord into
a mains power
socket
230V ~50Hz
THE DIGITAL TUNING CLOCK RADIO
Setting time
Press until and show
1
Press to set minute
Digital Tuning Radio
M1/M6
M3/M8 M4/M9
M2/M7
ALARM/
SET
CLOCK
41
HOUR ADJ MINUTE
[TUNING]
SNOOZE
3
2
M5/M10
MEMO
Press to set hour
3
Press to complete the setting
4
2
• Press and hold or
to skip fast
Adjusting display brightness
You may slide at the back of the unit to vary the LCD
display brightness.
HI DISPLAY LO
Listening to radio
1
4
2
VOLUME
Digital Tuning Radio
M5/M10
M1/M6
M3/M8 M4/M9
M2/M7
WAKE 1
WAKE 2
ALARM/
SET
NAP SLEEP
CLOCK
HOUR ADJ MINUTE
[TUNING]
RADIO on•off
ALARM off
SNOOZE
1
• To improve reception, you may try and reposition the unit or
extend the FM aerial wire
• Press and hold or for 2 sec to tune automatically
• If stations are in memory (see “Setting memory” for refer-
ence), you may skip and above and press the memory
buttons to access the corresponding memorised stations directly
• To turn off the radio, press again
max
min
MEMO
BAND
INTRO-SCAN
3
3
2
4
-
2
W AKE/
SET
CLOCK
+
-
W AKE/
SET
CLOCK
-
+
Press to turn on the radio
Press to select FM/LW
(RR-200PLL) or FM/MW (RR-200PLM)
Press or to your desired
station
Adjust to your desired
listening level
RADIO on•off
ALARM stop
1
BAND
2
VOLUME
2
min
-
+
max
+
3
RADIO on•off
ALARM stop
Untitled-3 7/17/01, 5:21 PM2
/6
M2/M7
3/ 8 / 9
THE DIGITAL TUNING CLOCK RADIO
J
N
M
O
RADIO on•off
ALARM stop
Using INTRO-SCAN
Intro-scan function allows you to listen to each tuned channel for a play
period of up to 10 seconds.
WAKE 1
NAP SLEEP
WAKE 2
ALARM/
SET
CLOCK
HOUR ADJ MINUTE
[TUNING]
RADIO on•off
ALARM off
SNOOZE
max
min
MEMO
BAND
INTRO-SCAN
• During the play period, you may:
-- Press or to keep scanning or change
scanning direction
-- Press to set memory (see “Setting Memory” for
MEMO
details)
• During the scanning or play period,
-- Press to exit the intro scan function
INTRO-SCAN
Setting memory
You may preset up to 10 radio channels
1
Digital Tuning Radio
M1/M6
M3/M8 M4/M9
M2/M7
ALARM/
SET
CLOCK
HOUR ADJ MINUTE
[TUNING]
3
SNOOZE
1. Press the memory buttons once to select M1...M5, twice to
select M6...M10
2. To exit from memory setting, press until
and the location number go off
2
M5/M10
MEMO
3
2
1
Follow and of “Listening to
1
radio” above
1
2
2
INTRO-SCAN
Press to start scanning
2
-
+
Tune to your desired station
Press andstarts
MEMO
blinking
M1/M6
M5/M10
Press ......
to designate memory location
MEMO
GB
THE DIGITAL TUNING CLOCK RADIO
Setting NAP
The NAP alarm allows you to take a nap for a period of 15
minutes up to 2 hours. After the set time period lapses, the
NAP alarm will sound to wake you up.
NAP
NAP
RADIO on•off
ALARM stop
NAP
S N O O Z E
SLEEP
Digital Tuning Radio
M5/M10
M1/M6
M3/M8 M4/M9
M2/M7
WAKE 1
WAKE 2
SET
NAP SLEEP
1
RADIO on•off
ALARM off
ALARM/
CLOCK
HOUR ADJ MINUTE
min
MEMO
[TUNING]
BAND
INTRO-SCAN
SNOOZE
Press and hold (and will
max
1
light) to set the desired time interval
after which the buzzer will sound
• While in NAP mode, presses on will show
the remaining time before the alarm sounds.
• To stop NAP buzzer from sounding, press
• To turn off the NAP cycle, press and hold until
goes off
Sleep to radio
You can drift off to sleep to radio knowing that the unit will turn itself
off automatically. If alarm is set, the unit will turn on again as programmed.
Press and hold to set the
1
WAKE 1
NAP SLEEP
RADIO on•off
ALARM off
Digital Tuni
M1/M6
M3/
M2/M7
WAKE 2
ALARM/
SET
CLOCK
HOUR AD
[TUNI
SNO
2
time from 2 hours to 15 minutes
and will light
2
Tune to your preferred station
• If you decide to turn off the unit sooner, press or
and this will shut off the sleep cycle.
• When sleep mode is active, subsequent presses on will show
the remaining time before the unit goes off.
• This unit allows you to “Sleep to one radio station and wake to
another”(see “Setting alarm with music” for setting alarm(s))
• If desired radio station is not selected, the unit will sleep to the
last receiving station.
SLEEP
Untitled-3 7/17/01, 5:21 PM3
Loading...